User manual ZIBRO 125

[. . . ] P 122 - P 125 2 6 5 3 FIN GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO MANUEL D'UTILISATION KYTTOHJE OPERATING MANUAL 4 16 28 40 52 64 4 2 ALLGEMEINE SICHERHEIT Aus Sicherheitsgrnden bitten wir Sie, die Bedienungsanleitung vor Inbetriebnahme sorgfltig zu lesen!Personen, die mit der Bedienungsanleitung nicht vertraut sind, drfen das Gert nicht bedienen. Kabel nicht zusammendrcken oder knicken. Nicht vor geffneten Fenstern aufstellen. [. . . ] The plug on the cable of the device must fit into the wall socket. The device must be placed on a flat and stable surface. The electricity supply to the device must be checked by a recognised professional if you have any doubts regarding the compatibility. This device is manufactured according to CE safety standards. Nevertheless, you must take care, as with any other electrical device. Do not cover the air inlet and outlet grill. Empty the water reservoir before moving the unit. Never allow the device to come into contact with chemicals. Never spray the unit with or submerge in water Do not insert objects into the openings of the unit. Always remove the plug from the electric power supply before cleaning or replacing the unit or components of the unit. Never use an extension cable to connect the device to the electric power supply. If there is no suitable, earthed wall socket available, have one installed by a recognised electrician. For safety reasons take care when children are in the surrounding of the device, as with any other electrical device. Have any repairs only carried out by a recognised service engineer or your supplier. Follow the instructions for use and maintenance as indicated in the user manual of this device. Always remove the plug of the unit from the wall socket when it is not in use. A damaged power cord or plug must always be replaced by a recognised electrician or your supplier. 4 66 ATTENTION! Never use the device with a damaged power cord, plug, cabinet or control panel. Never trap the power cord or allow it to come into contact with sharp edges. Never seal the room - where this device will be used - completely airtight. This will prevent under pressure in this room. Under pressure can disrupt the safe operation of geysers, ventilation systems, ovens, etc. The temperature can be set by pressing the and buttons, anywhere between 16C en 32C. The display will show the set temperature for 15 seconds and the "set temp" will light up. [. . . ] Continuous drainage is then necessary and more efficient. You must, however, use a water drain tube ( 0. 5 inch internal diameter), placing its discharge end at a suitable drainage point. H CLEANING WARNING! Switch off the unit and remove the plug from the mains before cleaning the appliance or filter, or before replacing the filters. Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol, detergents or other cleansing solutions. For maintenance of the filters, refer to Chapter D "Air Filter". NOTE! Never use the air conditioner without screenfilter. I STORAGE 1 Empty the internal water container (refer to Chapter F) 2 Clean and replace the mesh filter (see also chapter D). [. . . ]