User manual ZIBRO A 40

[. . . ] You may absolutely not connect the device if the power supply is not earthed. The plug must always be easily accessible when the device is connected. Do not connect the device with an extension cord. Never use the device with a damaged cord or plug. [. . . ] The HEPA/Enzyme filter and activate carbon filter continue to work for a long period of time after opening. The frequency of use and operating conditions determine how often the filters must be replaced. When the filter is new, the vertical filter lifetime bar lights up green. depending on the conditions , the lights will be de-activated stepwise. When the filter is saturated, the `Filter' light following steps: Switch the device off and remove the plug from the socket. Unfasten the front panel 1 with the push tabs 6 on both sides of the device. Remove the screen filter 7 from the device and then remove the H E PA-/Enzyme-filter 8 and the activated carbon filter 9. Clean the screen filter 7 with a vacuum cleaner. Install the new activ carbon filter, followed by the HEPA-/Enzyme-filter and finally the screen filter (see section B). press the reset button M after installing the screen filter 7. If you do not do this, the `Filter' light displayed. Dirty filters can be disposed of with household waste (not biologically degradable waste) without any problem. New filters are available at your dealer. Will remain on and the following filter replacement will not be switches on (red). When this happens, take the Always replace dirty filters with new filters. Never re-use a dirty filter, even after it has been cleaned. â· Depending on the circumstances it might be comfortable to replace the filters more frequent. Pressing the control button 2 again will change the mode as follows: Ions + AUTO Ions + Silence Ions + Normal Ions + High Ions + Fast light and a fan speed light The Timer , Smoke and Pollen modes can only be operated with the remote control. Use the remote control to operate the following functions: Use this button to switch the device on and off. To operate the timer, take the following steps: Switch the device on. On the display will switch on, which means that the device will button again to set an Switch off automatically after 1 hour. The Timer setting will be deleted when you switch the device off with the button. [. . . ] Any repairs or replacement of components during the warranty period will not result in an extension of the warranty period. The warranty will expire if any alterations have been made, not genuine components have been fitted or if the air purifier has been repaired by a third party. Components subject to normal wear and tear, such as the air filter, are not covered by the warranty. the warranty is only valid on presentation of the original , unaltered , and datestamped purchase receipt. [. . . ]