User manual ZIBRO D 2010

[. . . ] D 2010 6 = u FIN BRUGSANVISNING BRUKSANVISNING BRUKSANVISNING KYTTOHJE OPERATING MANUAL GEBRAUCHSANWEISUNG GEBRUIKSAANWIJZING MANUEL D'UTILISATION 2 8 14 20 26 32 38 44 4 2 1 3 11 2 - 3 sec. 26 Dear Sir, Madam, Congratulations with the purchase of your dehumidifier. You have acquired a high quality product which will give you many years of pleasure, if you use it responsibly. Please read the user's manual first in order to ensure the optimum life span of your dehumidifier. On behalf of the manufacturer, we provide a two-year warranty on material or manufacturing defects. [. . . ] Transportable dehumidifiers are ideal for the home and office. They improve the indoor climate, leading to a healthy environment. Dehumidifiers prevent mould and fungus while keeping the relative air humidity low, which ensures unfavourable conditions for dust mites. GENERAL INFORMATION ON DEHUMIDIFIERS: You may only see water in the water tank after approximately 8 days of using the dehumidifier for the following reasons: after transportation, the fuel in the dehumidifier needs time to `settle'. the built-in hygrostat needs time to determine the relative humidity of the room. there is a pipe linked to the permanent drain that must be filled up with water (happens automatically) before the water begins to drip down into the water tank. The air dehumidifier is suitable for dehumidifying a room of up to 60m3. However, this depends on the ambient temperature and the relative humidity. The effect of the air dehumidifier is higher at a combination of high temperature and high air humidity. A relative humidity of around 50% and below is recommended for living areas. 28 FUNCTIONS The appliance can run in either "Stand-Alone Mode", where all humidity is removed from the surrounding air and collected in the built-in water tank in the appliance, or "Continuous Draining Mode", where the water is removed from the air and led to an external drain via the built-in outflow using the attached plastic hose. STAND-ALONE MODE Here, the rubber plug is placed in the outlet pipe on the back of the appliance, and all humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on , the appliance switches off and also emits a short beep to show that the water tank is full. Once this happens, the water tank must be removed and emptied. When the empty tank is replaced, the dehumidifier starts again automatically. CONTINUOUS DRAINING MODE Here, the rubber plug is removed from the outflow pipe on the back of the appliance and one end of the accompanying transparent, flexible plastic pipe is pushed over the outflow pipe. (The rubber plug can be pushed over the protruding tap above the outflow pipe to avoid it getting lost). The other end of the plastic pipe is led downwards to a place where the humidity can drain away continuously. As a result, water does not collect in the built-in tank, and the visual and acoustic signals indicating that the built-in water tank is full do not function. The appliance runs continuously when used in this manner. FULL WATER TANK Using the "Stand-Alone" function, humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on, the appliance switches off and also emits a short beep to show that the water tank is full. When this happens, the water tank must be removed and emptied. [. . . ] The air filter can now be removed by pressing down the 2 pins on top of the filter and twisting the filter top off before the filter is removed. 2929 5. 7. The filter should be cleaned using a vacuum cleaner or rinsed under running water. It should then be left to dry in a location with good ventilation. Avoid using alcoholic detergents to clean the filter. [. . . ]