User manual ZIBRO D2010

[. . . ] ILLUSTRATION 3d: The appliance can also be used to dry gloves, handkerchiefs and small items of clothing. A small shelf accompanies the appliance on which small items of clothing can be hung to dry. The shelf can be attached to the dehumidifier by placing the shelf's two feet in the top slot of the grille on the air outlet. Smaller items of clothing placed on or hung down from the shelf can be dried using the hot air from the air outlet. [. . . ] GENERAL INFORMATION ON DEHUMIDIFIERS: You may only see water in the water tank after approximately 8 days of using the dehumidifier for the following reasons: · After transportation, the fuel in the dehumidifier needs time to `settle'. There is a pipe linked to the permanent drain that must be filled up with water (happens automatically) before the water begins to drip down into the water tank. the air dehumidifier is suitable for dehumidifying a room of up to 75m2. However, this depends on the ambient temperature and the relative humidity. the effect of the air dehumidifier is higher at a combination of high temperature and high air humidity. A relative humidity of around 50% and below is recommended for living areas. FUNCTIONS The appliance can run in either "Stand-Alone Mode", where all humidity is removed from the surrounding air and collected in the built-in water tank in the appliance, or "Continuous Draining Mode", where the water is removed from the air and led to an external drain via the built-in outflow using the attached plastic hose. STAND-ALONE MODE Here, the rubber plug is placed in the outlet pipe on the back of the appliance, and all humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on , the appliance switches off and also emits a short beep to show that the water tank is full. Once this happens, the water tank must be removed and emptied. When the empty tank is replaced, the dehumidifier starts again automatically. CONTINUOUS DRAINING MODE Here, the rubber plug is removed from the outflow pipe on the back of the appliance and one end of the accompanying transparent, flexible plastic pipe is pushed over the outflow pipe. (The rubber plug can be pushed over the protruding tap above the outflow pipe to avoid it getting lost). The other end of the plastic pipe is led downwards to a place where the humidity can drain away continuously. As a result, water does not collect in the built-in tank, and the visual and acoustic signals indicating that the built-in water tank is full do not function. The appliance runs continuously when used in this manner. fULL WATER TANK Using the "Stand-Alone" function , humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on, the appliance switches off and also emits a short beep to show that the water tank is full. When this happens, the water tank must be removed and emptied. Once the empty tank is replaced, the dehumidifier starts again automatically. The tank should be placed back in place for the appliance to run. The current room temperature and air humidity are shown in the electronic display. [. . . ] In case of replacement, the colour and model can be different from that of the original purchased unit. the initial purchase date shall determine the start of the warranty period. The warranty period is not extended if the unit is replaced or repaired by PVG or its officially appointed service centre. DISCLAIMER OF WARRANTY Damage or defects caused by incorrect treatment or operation and damage resulting from the use of nonoriginal parts or accessories not recommended by PVG are not covered by the warranty. [. . . ]