User manual ZIBRO D8

[. . . ] The installation must be in accordance with the regulations of the country where the unit is used. It has been approved by many safety institutions around the world. However, as with other electrical appliance, use it with care. do not clean the dehumidifier by spraying it or immersing it in water. [. . . ] When positioning your Zibro Clima dehumidifier, ensure that it is placed on a level surface clear of any obstacle that may limit the air movement. If you move the unit, it should first be switched off and the water tank emptied. The unit is switched off by turning the knob all the way anticlockwise. When a comfortable level of humidity is reached, turn the knob slowly anti-clockwise until the unit switches off. The dehumidifier will now automatically maintain the humidity at this level. fan Speed Control The dehumidifier features a two speed fan control. When the unit is switched on, the fan will start running in low speed. Select the desired speed with this switch. WATER FULL indicator When the water container is full, the WATER FULL indicator light will illuminate and the unit will automatically shut off. It will also beep several times to advise you hat the tank is full. see instructions for emptying the water container. The WATER FULL indicator light will also illuminate and the unit will beep if the water container has not been properly inserted or if it has been removed. Remember not to use this dehumidifier in temperatures below 4°C. When the water container is full the WATER FULL indicator light (I) will illuminate and the unit will automatically shut off. Wait a few minutes to allow the water to finish draining into the water container. To remove the water container, disconnect from the mains, pull out and lift the water container by the handle and carry it away for emptying. Gently replace the container and close the lower front panel. When the tank is properly inserted, both the hole and the float mechanism in the container will be located directly beneath the drainage spout and the WATER FULL indicator light(I) will go out. It may be more convenient to set up the dehumidifier for continuous drainage with the following procedure: · Remove the water container from the unit; Click the supplied spout (the long end depressing the microswitch) firmly in place; Place an appropriately sized drainage pipe over the spout inside the housing; Place the other end of the pipe in a drain, ensuring that: - it Is not twisted, folded, or otherwise likely to obstruct the water flow, - the spout is not under the water level of the drain; · There must be a gradual downward slope from the spout to the drain. In very cold weather conditions precautions should be taken to prevent the drainage pipe from freezing. To return to water container use, take the spout out and replace the water container. Clean regularly with a common, non abrasive, household detergent, without solvents. [. . . ] 2 Repairs to or replacement of components within the guarantee period will not result in an extension of the guarantee. 3 The guarantee is invalidated if any modifications have been made, non genuine parts are fitted or repairs are carried out by third parties. 4 Components subject to normal wear, such as the filter, are not covered by the guarantee. 5 The guarantee is valid only when you present the original, dated purchase invoice and if no modifications have been made. [. . . ]