User manual ZIBRO KRA106

[. . . ] Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] Then slowly turn the wick adjuster knob · counter-clockwise to its stop. The flame will extinguish after a little while. These methods may cause unwanted odour, soot and smoke. Only the wick adjuster knob should be used for normal shutoff. NOTE: In case of an emergency, switch off the heater by turning the safety button counterclockwise (Fig. After a period of time the combustion may no longer be high enough (Section D). in that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Follow the procedure below: 1 Release the automatic extinguisher by turning the safety button counterclockwise. Off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the wick adjuster knob · This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig. Q), the wick height lock should be placed one position lower again. If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled , wait for 30 minutes before igniting the heater. [. . . ] Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 1 We expressly dismiss all other claims for damages, including consequential damages. 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. 3 The warranty will no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. [. . . ]