User manual ZIBRO LASER

[. . . ] Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable domestic heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure a maximum lifetime for your Zibro Kamin heater. [. . . ] When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. The heater is burning, the ON/OFF button will remain lit (red). the information display will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start switch on the function (the TEMP light next to the information display Next, adjust the temperature using the key on the left ( HOUR) to set the temperature to a higher setting and the key on the right ( MIN) to lower the temperature. press once to increase the value one step. After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the ON/OFF button and then the TIMER key immediately after that. The TIMER light and the information display 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. HOUR) to set the hours and the key on the right 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the ON/OFF button once to clear the timer setting. There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. [. . . ] Your Zibro Kamin needs hardly any maintenance. It is, however, important that you clean the air filter and the vent filter with a vacuum cleaner and the grid with a damp cloth, both on a weekly basis. remove the air filter occasionally (Fig. Some drops may leak from the filter; keep a cloth at hand. [. . . ]