User manual ZIBRO LASER FF 55

[. . . ] Laser FF 55 3 4 1 TR MANUEL D'UTILISATION OPERATING INSTRUCTIONS GEBRUIKSAANWIJZING KULLANIM KILAVUZU 2 24 46 68 4 OPERATING INSTRUCTIONS Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. [. . . ] Make sure that it is in a higher position than the removable tank. Insert the ribbed hose into the opening of the removable tank. empty full Note: Some drops may leak from the tank. Put down the removable tank (cap pointing upwards) and screw off the fuel cap using the fuel cap cover. [7] Let the remaining fuel in the pump flow back into the jerry can and carefully remove the pump. Carefully screw the fuel cap back on the tank using the fuel cap cover. After use, re-store the cover at the rear of the heater. [8] Check whether the fuel cap is straight an tightened properly. Reinstall the removable tank in the heater (cap down). Close the tank lid. Step 2: Plug in the heater Insert the plug into the wall-socket (230 Volts AC/50Hz). Step 3: Setting the clock Important: The clock on the heater must always be set to the correct time. It is only possible to set the correct time, when the heater is connected to the mains and not burning. Use the adjustment buttons to set the time. First press either of the two buttons to switch on the 40 Chapter 2, OPERATION function (the CLOCK light and the information display will start blinking). Next, set the hours using the button on the left ( hour) and the minutes using the button on the right ( min. ). Press once to increase the value by one step. When you hold down the button, the value will continue going up, until you release the button again. After approximately 10 seconds the blinking will stop and the setting will be locked. After switching off the heater, the clock time will be displayed. 5. Igniting the heater The heater is operated directly by the user. However, the heat yield is controlled automatically in accordance with the room temperature registered by the temperature sensor. Step 1: Switch the heater ON Press the ON/OFF button. The current room temperature and the set temperature are displayed on the information display. The ON/OFF light starts to flash, after which the heater will switch on. perature using the button on the right ( min. ) to set the temperature to a higher setting and the button on the left ( hour) to lower the temperature. [. . . ] Contact your dealer Contact your dealer Contact your dealer Refill removable tank. Check the position of room temperature sensor. Check the position of room temperature sensor. Lo 44 Chapter 1, INSTALLATION Your heater comes with a 24-months warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. [. . . ]