User manual ZIBRO LASER56

[. . . ] Laser 56 3 2 6 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING OPERATING INSTRUCTIONS ISTRUZIONI D'USO GEBRUIKSAANWIJZING 3 27 51 75 98 122 4 OPERATING INSTRUCTIONS Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. [. . . ] The switch activates and deactivates the automatic operation setting as programmed in the timer. Temperature adjustment button "NORMAL" and "SET-BACK" temperature selection switches offer the user the option to select the desired temperature during manual or automatic operation. Buttons to adjust the clock and the timer Timer and clock settings can be adjusted by pressing the hour and minute buttons. Time selector switch When the timer and the clock have been programmed and you wish to see a time indication, return the selector switch to the `normal' position. The start and finish times of "SET-BACK" (timer) are also set with this switch. Information display Displays the clock, set temperature, room temperature and error codes. Operating mode lights - indicate whether the heater is operating at the "HIGH", "MEDIUM" or "LOW" setting. - Indicate when the heater is operating and flash when the heater is in the cleaning mode. - Switch on when the heater is operated manually or in "NORMAL" automatic operation. - Switch on when the heater is "SET-BACK" setting of automatic operation. 91 Chapter 2, OPERATION 4. Prior to use Step 1: Open the valve(s) Screw the valve on the top of the removable tank open or open the valve for the external fuel tank and the fire safety valve of the heater (if present). Step 2: Start the fuel supply Carefully press the red unlocking button for one second to release the float in the fuel receptacle. The fuel receptacle only has to be unlocked when the heater is activated for the first time or after it has run out of fuel, or if the heater has not been used for an extended period of time. Unlocking may also be required if the fuel inlet pressure exceeds 2. 5 psi ( 0. 17 bar). In this case, a pressure reduction valve must be installed. Step 3: Adjust the clock Important: The clock on the heater must always be set to the correct time. Switch the time selector switch to "CLOCK SET" B. Press the "HOUR" and the "MINUTE" buttons to adjust the hours and minutes. Pressing the "HOUR" or "MINUTE" button once will adjust the time by one unit (hours or minutes respectively). Holding the button down accelerates the adjustment of the time display. All clock and timer settings are deleted if the power is cut off for a period longer than 10 seconds. The information display flashes "PM 12:00" when the heater is switched off. [. . . ] Leaking exhaust pipe. Odours. Fuel leak. EE8 EE10 Hi Lo Defective blower motor Heater will not switch off. The room temperature is higher than 35 C. The room temperature is lower than 10 C. Warning: Stop using the heater if error EE10 occurs. [. . . ]