User manual ZIBRO P 832

[. . . ] P 820 - P 828 - P 832 2 6 5 3 4 > 1 : TR BEDIENUNGSANLEITUNG BRUGSANVISNING INSTRUCCIONES DE USO MANUEL D'UTILISATION OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING INSTRUKCJA OBSLUGI KULLANIM KILAVUZU 4 18 32 46 60 74 88 102 116 2 ALLGEMEINE SICHERHEIT Aus Sicherheitsgrnden bitten wir Sie, die Bedienungsanleitung vor Inbetriebnahme sorgfltig zu lesen!Personen, die mit der Bedienungsanleitung nicht vertraut sind, drfen das Gert nicht bedienen. A. Kabel nicht zusammendrcken oder knicken. Nicht vor geffneten Fenstern aufstellen. [. . . ] CONNECTING TO THE MAIN Insert the plug in the wall socket. Then press to switch the unit on or off. A buzzer will beep, and the LCD will display 12:00 o'clock as default. SETTING THE CLOCK 88:88 88:88 Press the push button for 3 seconds to set the clock. The 2 left digits of the 4 digits on the LCD-display will flash. Press Press Press Press the or to adjust the hour. momentarily, the 2 right digits of the 4 digits will flash. push button for 3 seconds again to activate the clock. 3. TEMPERATURE SETTING UP/DOWN If you want to change the set temperature press The 2 digit display will indicate the set temperature. to adjust the minutes of the clock in intervals of 5 minutes. The timer is set. After 10 seconds the time display returns. The circular time scale will be on between the present time to the OFF programmed time. The flashing bar on the time scale indicates the real time and moving a phase every 30 minutes ahead until it reaches the OFF timer time, then the black segments in the circular time scale will disappear. Repeat OFF & ON Programming the timer for repeat OFF & ON - when the unit is running. 88:88 88:88 Press the are flashing. Press Press the Press or or push button; the 2 left digits of the 4 digits on the LCD display to adjust the hour. push button again, the 2 right digits of the 4 digits are flashing. to adjust the minutes of the clock in intervals of 5 minutes. The timer is set. After 10 seconds the time display returns. Repeat the above procedure while the digits are still flashing for setting the ON. The circular time scale will be on between the 00:00 time to the timer time off, and from the time on till 24:00. The flashing bar on the time scale indicates the real time and moving a phase every 30 minutes ahead. The unit will operate according to the timer setting daily. Repeat ON & OFF Programming the timer for repeat ON & OFF - when the unit is not running. 88:88 Press the are flashing. push button; the 2 left digits of the 4 digits on the LCD display 4 66 Press or to adjust the hour. [. . . ] Clean or replace filter (refer to Chapter D). Place on even surface (less vibrations). Wait 3 minutes until the temperature has decreased, and turn on the unit again. Make sure the remote control is correctly aimed at the control panel. [. . . ]