User manual ZIBRO P629

[. . . ] P 622 - P 629 - P 639 2 6 5 3 4 > 1 : BEDIENUNGSANLEITUNG BRUGSANVISNING INSTRUCCIONES DE USO MANUEL D'UTILISATION OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING INSTRUKCJA OBSLUGI 4 18 32 46 60 74 88 102 2 ALLGEMEINE SICHERHEIT Aus Sicherheitsgrnden bitten wir Sie, die Bedienungsanleitung vor Inbetriebnahme sorgfltig zu lesen!Personen, die mit der Bedienungsanleitung nicht vertraut sind, drfen das Gert nicht bedienen. A. Kabel nicht zusammendrcken oder knicken. Nicht vor geffneten Fenstern aufstellen. [. . . ] 5 Connect the hose to the unit by turning it clockwise (at least 5 turns). 6 Connect the hose to the slidebar connector as far as possible. 4 63 7 Fit the telescopic slide bar slidebar connector to the window and adjust the length. Put the in the opening in the telescopic slide bar. Close the has a free flow outside. window or door as much as possible to prevent outside air entering the room. 2 Press 3 Press the 4 Press or or push button; the 2 left digits of the 4 digits on the LCD display to adjust the hour. push button again, the 2 right digits of the 4 digits are flashing. to adjust the minutes of the clock in intervals of 5 minutes. The timer is set. After 10 seconds the time display returns. The circular time scale will be on between the ON programmed times until 24:00. The flashing bar on the time scale indicates the real time and moving a phase every 30 minutes ahead until it reaches the ON timer time, then the black segments in the circular time scale will disappear. 4 65 OFF Programming the timer for OFF - when the unit is running. 88::88 88:88 1 Press the are flashing. 2 Press 3 Press the 4 Press or or push button; the 2 left digits of the 4 digits on the LCD display to adjust the hour. push button again, the 2 right digits of the 4 digits are flashing. to adjust the minutes of the clock in intervals of 5 minutes. The timer is set. After 10 seconds the time display returns. The circular time scale will be on between the present time to the OFF programmed time. The flashing bar on the time scale indicates the real time and moving a phase every 30 minutes ahead until it reaches the OFF timer time, then the black segments in the circular time scale will disappear. Repeat OFF & ON Programming the timer for repeat OFF & ON - when the unit is running. 88::88 88:88 1 Press the are flashing. 2 Press 3 Press the 4 Press or or push button; the 2 left digits of the 4 digits on the LCD display to adjust the hour. push button again, the 2 right digits of the 4 digits are flashing. to adjust the minutes of the clock in intervals of 5 minutes. The timer is set. After 10 seconds the time display returns. 5 Repeat the above procedure while the digits are still flashing for setting the ON. [. . . ] Clean or replace filter (refer to Chapter D). Place on even surface (less vibrations). Wait 3 minutes until the temperature has decreased, and turn on the unit again. Make sure the remote control is correctly aimed at the control panel. [. . . ]