User manual ZIBRO P726

[. . . ] For safety reasons, please read this manual carefully before operating. Persons who are not familiar with this manual must not use this air conditioner. We strongly recommend keeping this manual in a safe place for future reference. Do Do Do Do Do Do not not not not not not use a damaged cable. [. . . ] The exhaust air must be able to flow out unhindered. If this is not possible this may lead to overheating or water condensation in the air exhaust hose µ. This is why you must ensure that there are no kinks or sharp corners in the air hose(s). To obtain an optimum result, the air hoses must be kept shorter than 1 metre while the airconditioner is in use. Symbols: Automatic Cooling Dehumidify Circulate air Heat (only by PH 733) High ventilator speed Average ventilator speed Low ventilator speed Without the remote control, the air-conditioner can be operated by using the button on the front of the device. In this event however, only the automatic function can be used. PLACING BATTERIES IN THE REMOTE CONTROL Remove the battery cover by pressing the lips in and then pulling the cover toward you. Replace batteries with new batteries of the same type when the display becomes fuzzy or the signal deteriorates. If the airconditioner does not respond to the remote control, follow the following procedures: · And hold it down until after the beep signal after approximately 8 seconds. The remote control is ready for use after the beep signal. 3 The following functions can be selected with the mode button remote control. The following settings are possible in the cooling mode: · The ventilator speed can be adjusted by pressing the Automatic regulation of ventilator speed High Average Low -button The temperature can be set between 18°C and 32°C by pressing the buttons. Whether the desired temperature can actually be reached depends on the ambient conditions. The room temperature remaining above the set temperature is normal. DEHUMIDIFICATION When the dehumidification mode is activated, the transparent ring around the button on the front of the device · The dehumidification function can be used in different ways. 1) All models: Only connect the air exhaust hose µ to the air outlet ¿ and lead it outside, as when using the device in the cooling function with a single hose. place the hose in such a way that the hot air is expelled outside. The device will then dehumidify the air in the room and remove excess moisture through the air hose. 2) All models: Do not connect both the air supply ¾ and the air exhaust hose µ. Into the water drain Lead the other end to a drain or sink and insert the plug Do not connect both the air supply ¾ and the air exhaust hose µ. 5 m from the floor on which the device is standing. Exceeding this distance may damage the machine or cause leaks. [. . . ] The device does not work and the transparent ring around the button on the front of the device flashes RED. The device does not work and the top horizontal edge of the transparent ring The room temperature around the button on the sensor is defective. The device does not work and the lower horizontal edge of the transparent ring around the button on the front flashes BLUE. The temperature sensor of the heat exchanger is disrupted or has short circuited. [. . . ]