User manual ZIBRO P90

[. . . ] Customer service department The installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the electrical installation, have it checked and if necessary modified by a qualified electrician. However, as with other electrical appliances, use it with care. do not clean the air conditioner by spraying it or immersing it in water. [. . . ] Place the foam in the window and close this as far as possible to refrain the warm air from re-entering the room. The window connector Place the window connector (13) in the hole in the glass (diameter 112 millimetre) and connect the exhaust hose. Use the cap (14) to close the opening when the air conditioner is not used. The flexible exhaust hose can be extended from 300 to 1500 mm for mounting. This length has been designed especially according to the specifications of the air conditioner. Do not use an extension or exchange for a different hose as that may lead to malfunctioning. The exhaust air must flow freely, any blockage can lead to overheating of the air conditioner. Take care to prevent any bow or bend in the exhaust hose. The unit switches off automatically when the selected time has run down. 2 Mode knob Select with this knob either low or high ventilation speed or low or strong cooling. 3 Thermostat knob Turn this knob to maintain the temperature level in combination with cooling. The compressor has been set so that it starts functioning three minutes after the (re)start of the air conditioner. The cooling will switch off when the room temperature is lower than the set one. Ventilation will however continue to work on the set level. When the room temperature rises above the selected value, the cooling will work again. LED lights when the water tank is full, the compressor is stopped and the fan only circulates the air. 1 Switch off the unit and remove the plug from the mains. 4 Remove the rubber plug and fill the water tray then replace the plug to stop the water flow. Empty the tray and repeat this process until all water has been removed. When the air conditioner is in use, under normal circumstances the condensed water will be drained through the air outlet-tube. 1 Switch off the unit and remove the plug from the mains. 4 Connect the drain tube into the water outlet and extend with extra water tube as needed. [. . . ] The guarantee is invalidated if any modifications have been made, non genuine parts are fitted or repairs are carried out by third parties. Components subject to normal wear, such as the filter, are not covered by the guarantee. The guarantee is valid only when you present the original, dated purchase invoice and if no modifications have been made. The guarantee is invalid for damage caused by neglect or by actions that deviate from those in this instruction booklet. [. . . ]