User manual ZIBRO R 417 TC

[. . . ] R 417 TC 3 2 6 5 4 > 1 : MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING INSTRUCTIONS ISTRUZIONI D'USO GEBRUIKSAANWIJZING INSTRUKCJI OBSLUGI 2 14 26 38 50 62 74 86 Dear Sir, Madam, Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] To do this, the heater must have been switched off. Follow the procedure below: 1 Push the OFF - button (Fig. M). 4 55 N 2 Pull the knurled wick adjustment knob off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. G F broken ignition coil If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig Q), the wick height lock should be placed one position lower again. Otherwise smoke or soot may be caused. MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your Zibro dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing down the igniter slide with too much force. Push it down less forcefully (Section C). IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. The flame height has not been adjusted properly. You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. You are using the incorrect type of fuel. [. . . ] And then install the top of the stem into the groove of the wick sleeve (with wick) from right side, and left the stem to the end. 14 Install the wick height lock (the wick position should be adjusted at No. Then tighten the screw which is holding the stem. 15 Put the wick holder chassis back into position. 13a 13b 1 4a 1 4b 16 Screw the four wing nuts hand tight. [. . . ]