User manual ZIBRO R 421 E

[. . . ] R 421 E 3 2 6 5 FIN MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO KYTTOHJE OPERATING MANUAL ISTRUZIONI D'USO BRUKSANVISNING GEBRUIKSAANWIJZING INSTRUKCJI OBSLUGI BRUKSANVISNING 2 14 26 38 50 62 74 86 98 110 122 4 > u 1 : = Dear Sir, Madam, Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] After improving the ventilation of the room (e. g. by opening a door or window a little more), the heater can be ignited again. This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. E L SWITCHING OFF THE HEATER Let the heater burn at its lowest setting for approximately one minute. The flame will extinguish after a little while (Fig. L). In cases of emergency: switch off the heater with the OFF - button (Fig. L). 4 67 R F ADJUSTING THE WICK HEIGHT After a period of time the combustion may no longer be high enough (Section D). In that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Follow the procedure below: 1 Push the OFF-button (Fig. 2 Pull the knurled wick adjustment knob off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. F If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig P), the wick height lock should be placed one position lower again. Otherwise smoke or soot may be caused. G MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your Zibro dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Reinstall the wick height lock (Section F). H MAINTENANCE Your heater needs hardly any maintenance. It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. [. . . ] Ensure that you are wearing gloves and that you have a container in which to put the old wick. 9 10 11 4 72 12a 12b 12 Install the wick to the wick sleeve according to the allowed direction engraved on the wick sleeve. 13 Install the wick sleeve (with wick) to the primary air tube. And then install the top of the stem into the groove of the wick sleeve (with wick) from right side, and left the stem to the end. 14 Install the wick height lock (the wick position should be adjusted at No. [. . . ]