User manual ZIBRO R14

[. . . ] R 14 3 2 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 14 26 38 50 62 Dear Sir, Madam, Congratulations on your purchase of this heater. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] N). N MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing the ignition button with too much force. Contact your dealer. F 4 43 IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. You are using the incorrect type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Dust has gathered in the lower part of the heater. THE HEATER SLOWLY EXTINGUISHES The removable tank is empty. The lower reservoir is contaminated by moist. The wick has hardened on the upper side. Burn the heater until all fuel is used (Section G). You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. THE HEATER REMAINS BURNING LOW Wick position too low. Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. [. . . ] Ensure that you are wearing gloves and that you have a container in which to put the old wick. 11 4 48 12a 12b 12 Install the wick to the wick sleeve according to the allowed direction engraved on the wick sleeve. 13 Install the wick sleeve (with wick) to the primary air tube. And then install the top of the stem into the 13a 13b groove of the wick sleeve (with wick) from right side, and left the stem to the end. Then tighten the screw which is holding the stem. [. . . ]