User manual ZIBRO R19C

[. . . ] Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your Zibro Kamin heater. [. . . ] After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section M) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. The flame will extinguish after a little while. After a period of time the combustion may no longer be high enough (Section D). in that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Off the heater, so the wick height lock ¸ will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig Q), the wick height lock should be placed one position lower again. If any malfunctioning cannot be solved from the directions below, please contact your dealer. [. . . ] If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. Always start the new heating season with fresh fuel. When you start re-using the heater, follow the instructions again (starting from Section A and as specified). Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. [. . . ]