User manual ZIBRO R210C

[. . . ] This appliance comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort from your Zibro heater. Yours sincerely, PVG International b. v. Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 50 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. For more details, please refer to the MANUAL (pages 53 ff. ). MAIN COMPONENTS OFF Button Knurled wick adjustment knob 1 2 Remove all packaging materials (refer to Section A, Fig. Fill the removable tank and wait 30 minutes before you ignite the heater (refer to Section B, Fig. [. . . ] Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. R). M VENT. If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section M) When there is insufficient ventilation in the room, an intermittent buzzer will be heard and the VENT lamp (Yellow) will be lit. When this signal is given, ensure that the ventilation of the room is improved (e. g. by opening a door or window a little more) to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT lamp and buzzer will be deactivated. When there is still insufficient ventilation, the heater shuts off automatically. After improving the ventilation of the room (e. g. by opening a door or window a little more), the heater can be ignited again. This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. You are using the incorrect type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Dust has gathered in the lower part of the heater. THE HEATER SLOWLY EXTINGUISHES The removable tank is empty. The fuel filter is contaminated by moist. The lower reservoir is contaminated by moist. The wick has hardened on the upper side. Burn the heater until all fuel is used (Section H). You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. THE HEATER REMAINS BURNING LOW Wick position too low. [. . . ] 11 Squeeze the wick to loosen the three wick pins and 9 10 remove the wick from the wick sleeve. Ensure that you are wearing gloves and that you have a container in which to put the old wick. 11 4 60 12a 12b 12 Install the wick to the wick sleeve according to the allowed direction engraved on the wick sleeve. 13 Install the wick sleeve (with wick) to the primary air tube. And then install the top of the stem into the 13a 13b groove of the wick sleeve (with wick) from right side, and left the stem to the end. [. . . ]