User manual ZIBRO R27C

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro Kamin. Below you will find the main steps to be taken for using your Zibro Kamin. ² ¶ Ignite the heater using the ON/OFF key (refer to Section D). [. . . ] You should therefore provide extra ventilation. The heater is burning, the ON/OFF button will remain lit (red). the information display ¹ will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to MIN) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( HOUR) to lower the temperature. press once to increase the value one step. The KEY-LOCK indicator light will light up (Fig. i) , indicating that the childproof lock has been activated. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. Switch off the function by pressing the SAVE key once again. Without the 'SAVE' setting your heater will maintain the set temperature by Approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display ¹ (fig. [. . . ] At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. Unused fuel cannot be used in the next heating season. We therefore recommend that you burn up all fuel. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. [. . . ]