User manual ZIBRO R316C

[. . . ] Intermittence CONSEILS D'UTILISATION ET D'ENTRETIEN CONSEILS D'UTILISATION ET à l'appareil et Se reporter à la notice jointeD'ENTRETIEN à la plaque de sécurité sur Se reporter l'appareil à la notice jointe à l'appareil et à la plaque de sécurité sur l'appareil Référence et numéro de lot ou de série de l'article : se reporter au produit Référence et numéro de lot ou de série de l'article : se reporter au produit Distributed in Europe by: Distributed in Europe by: PVG International B. CONSEILS D'UTILISATION ET D'ENTRETIEN CONSEILS D'UTILISATION ET D'ENTRETIEN Se reporter à la notice jointe au convecteur et aux indications figurant Se reporter à la notice jointe au convecteur et aux indications figurant sur l'emballage de la mèche. Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. [. . . ] 8 Check whether the fuel cap is straight and tightened properly. A new heater may give off some smells for a short while, when it is used for the first time. You should therefore provide extra ventilation or ignite the heater outside the living room. When you use the heater for the first time, first put the filled removable tank into place, and then wait approximately 30 minutes before you ignite the heater. this allows the glass fibre wick to soak up the fuel. Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Always ignite the heater with the electrical igniter. This will also activate the safety device. 2 As soon as you can see a small flame in the combustion chamber », you can let go of the controls. After having ignited the heater, always check whether the combustion Chamber » is level, by sliding it slightly to the left and the right by its handle ¿ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater for more than 5 seconds. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. The flame will extinguish after a little while. If any malfunctioning cannot be solved from the directions below, please contact your dealer. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing down the slide controls · With too much force. [. . . ] Follow the procedure on the next page: 1 Ignite the heater outside the living room and let it burn until all fuel is used. 3 Clean the heater with a damp cloth and then dry it with a dry cloth. 4 Remove the batteries from the holder µ and store them in a dry place. Unused fuel cannot be used for the next heating season. [. . . ]