User manual ZIBRO R31E

[. . . ] R 20 E / R 21 E / R 31 E 3 2 5 FIN MANUEL D'UTILISATION GEBRAUCHSANWEISUNG INSTRUCCIONES DE USO KYTTOHJE OPERATING MANUAL ISTRUZIONI D'USO BRUKSANVISNING GEBRUIKSAANWIJZING BRUKSANVISNING 2 14 26 38 50 62 74 86 98 4 > u 1 = Dear Sir, Madam, Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your Zibro heater. [. . . ] by opening a door or window a little more), the heater can be ignited again. This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. E F N SWITCHING OFF THE HEATER Push the OFF-button . The flame will extinguish after a little while. ADJUSTING THE WICK HEIGHT (R21E) After a period of time the combustion may no longer be high enough (Section D). In that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Follow the procedure below: 1 Push the OFF button (Fig. 2 Pull the knurled wick adjustment knob off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. O 4 55 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. F If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig R), the wick height lock should be placed one position lower again. Otherwise smoke or soot may be caused. G MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. There is not enough power left in the batteries for the ignition. R21E: Reinstall the wick height lock (Section F). R31E: Contact your dealer. H MAINTENANCE Your heater needs hardly any maintenance. It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Under normal conditions, only three components are subject to wear: 1. THE BATTERIES You may replace the batteries yourself. [. . . ] 14 Install the wick height lock (the wick position should be adjusted at No. Then tighten the screw which is holding the stem. 15 Put the wick holder chassis back into position. 17 Place the knurled wick adjustment knob on the wick mechanism. [. . . ]