User manual ZIBRO R420E

[. . . ] 225 g/h 2700 Watt Conseiller pour des pièces normalement minimum 45 maximum 95 3 airées(m )** Ne convient pas pour des pieces de volume 45m3/18m2 inférieur à** Consommation de combustible (l/heure)* 0, 281 Consommation de combustible (g/heure)* 225 Autonomie du réservoir (heures) minimum 14 4, 0 Contenance du réservoir amovible (litres) Poids (kg) 9, 0 428 largeur Dimensions (mm) (plateau inférieur compris) profondeur 295 hauteur 513 Accessoires pompe à main, bouchon de transport Piles 4x LR20, MN 1300, 1, 5V, size D Type mêche F Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] When this signal is given, ensure that the ventilation of the room is improved (e. By opening a door or window a little more) to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT lamp and buzzer will be deactivated. When there is still insufficient ventilation, the heater shuts off automatically. After improving the ventilation of the room (e. By opening a door or window a little more), the heater can be ignited again. This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. Let the heater burn at its lowest setting for approximately one minute. The flame will extinguish after a little while (Fig. In cases of emergency: switch off the heater with the safety device ³ (Fig. After a period of time the combustion may no longer be high enough (Section D). in that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Off the heater, so the wick height lock will be visible. 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. [. . . ] Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). Never use the heater in places where harmful gasses or fumes may be present (e. Do not cover the heater (there is a risk of fire). Avoid any concact with the top plate and grille. [. . . ]