User manual ZIBRO R44C

[. . . ] model Cooling capacity * EE Class EER * Heating capacity COP Class COP * Dehumidification capacity (max) ** Power consumption cooling Power consumption heating Mains Current (nom) Airflow (max) For rooms up to Dimensions indoor unit (WxDxH) Dimensions outdoor unit (WxDxH) Weight indoor unit Weight outdoor unit Refrigerant/charge Noise level indoor unit (max) Noise level outdoor unit (max) Operating range Unit protection indoor Unit protection outdoor Ltr/day kW kW Volt/Hz/Pf A m /h m Defective electrical devices and batteries must be kept separate from household waste. Ensure that there is effective recycling where possible. Ask you local council or dealer for expert advice on recycling. The diagrams in these instructions are based on a standard model. [. . . ] Create a recess that corresponds with the direction of the pipes. Note: create recess 1, 2 or 4, depending on the position you have chosen for the hole in the indoor unit. Fit the drainage hose after connecting the wires/pipes. finish by insulating the pipes , cables and drainage hose. Insulation of the pipe connections: Insulate the connection pieces with insulating material and then wrap them in vinyl tape. The drainage hose must slope downwards slightly in order to allow moisture to drain away easily. Ensure that the drainage hose is not twisted and does not protrude. If the wire/pipes are on the right hand side, the wires/pipes, power cable and drainage hose must be insulated and fastened to the back of the indoor unit with a pipe clamp. If the drainage hose is extended with a hose, the section running alongside the indoor unit must be Push through here Connect the indoor unit pipes with two nut spanners. Select the correct tightening moment in order to prevent the pipes, connecting pieces and nuts from being deformed or damaged. First tighten by hand, and then with nut spanners. Turn the two-way and three-way valves to their operating positions. Note Read these instructions for use before commencing installation. make sure that no air remains in the cooling system and that no refrigerant is leaking. Testing: switch the air conditioner on after installation and take notes on the operation. The fuse for the unit as a whole must be suitable for maximum power. The plug must be easily accessible in order to be able to switch the unit off in case of emergency. If there is no easy access, a bipolar main switch must be installed at an easily accessible location. OPERATING INDICATOR Lit when the unit is in operation. EMERGENCY BUTTON To operate the unit if the remote control is not operational. EMERGENCY BUTTON To operate the unit if the remote control is not operational. Following a power cut, the machine will resume operation in the last selected function. [. . . ] Press the Timer button again to display the time, which can now also be adjusted*. Check that the TIMER INDICATOR on the indoor unit lights up after the timer has been set. Switch the machine off and remove the plug from the socket. Hold the front panel at position "a" and pull it towards you. [. . . ]