User manual ZIBRO R50C

[. . . ] This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. [. . . ] Either of the two keys to switch on the function (the CLOCK light and the information display ¹ will start blinking). Next, set the hours using the key on the left ( hour) and the minutes using the key on the right ( min. When you hold down the key, the value will F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. Continue going up, until you release the key again. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . The light next to them indicates that these numbers refer to the temperatures (Fig. Always contact your dealer for any malfunctioning not listed above. When te heater has been burning continuously for two hours at its highest The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I: When the KEY-LOCK light lights up, the childproof lock has been activated. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down The KEY-LOCK indicator light will light up (Fig. i) , indicating that the childproof lock has been activated. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. J: When the SAVE light v lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. [. . . ] We recommend that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Do not remove any heater components yourself. Always contact your Zibro dealer for repairs. When the power cord is damaged, it may only be replaced by an authorised fitter. [. . . ]