User manual ZIBRO R56C

[. . . ] Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable heaters. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] Always ignite the heater with the igniter slide. never use matches or cigarette lighters. Follow the procedure below: 1 Slowly push down the igniter slide » together with the flame regulator · At the same time you will activate the safety device. 2 Release the igniter slide as soon as a flame is visible at the bottom of the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the flame regulator · Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (leave window or door ajar) (contact your dealer or replace the wick, refer to section L) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater for more than 5 seconds. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. Let the heater burn at its lowest setting for approximately one minute. In cases of emergency: switch off the heater with the safety device ³ (fig. If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing down the igniter slide » with too much force. Push it down less forcefully (Section C). Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. [. . . ] Unused fuel cannot be used for the next heating season. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. 7 Always start the new heating season with fresh fuel. When you start re-using the heater, follow the instructions again (starting from Section A and as specified). [. . . ]