User manual ZIBRO R610C

[. . . ] This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your Zibro heater. This appliance comes with a 48-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort from your Zibro heater. Yours sincerely, PVG International b. v. Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 50 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. [. . . ] When you have ignited the heater and it shuts off again shortly after, the batteries need to be replaced. It is best to use new alkaline batteries (4x D-size). 4 54 If the heater has been used only a few times and the wick adjustment knob is not locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the wick in the highest position for ignition (Section C). E After having ignited the heater, always check whether the combustion L chamber is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. D BURNING OF THE HEATER After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. R). S VENT. If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section M) When there is insufficient ventilation in the room, an intermittent buzzer will be heard and the VENT lamp (Yellow) will be lit. When this signal is given, ensure that the ventilation of the room is improved (e. g. by opening a door or window a little more) to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT lamp and buzzer will be deactivated. Under normal conditions, only two components are subject to wear: 1. THE BATTERIES You may replace the batteries yourself. Do not dispose of old batteries along with the other domestic waste. Follow the locally applicable regulations regarding the disposal of domestic chemical waste. THE WICK To extend the glass fibre wick life, you must occasionally let the heater burn until the tank is completely emptied and the heater extinguishes by itself. Do this when you notice that the flame is weakening. The burn-out will cause some smells, so it is recommended that you take the heater outside of the living room. THE FUEL FILTER Check the fuel filter regularly as well. Remove the removable tank from the heater and take out the fuel filter (Fig. Some drops of fuel may spill from the filter; keep a cloth at hand. Turn the fuel filter upside down and clean it from all dirt deposits by tapping it on a hard surface. [. . . ] 8 Squeeze the wick to loosen the three wick pins and remove the wick from the wick holder. Ensure that you are wearing gloves and that you have a container in which to put the old wick. 6 7 9 Put the wick holder back into position in such a way that the holes in the wick holder are directly above the inner sides of the recesses in the burner. 10 Fold a new wick and place it in the wick holder. Push the three wick pins into the wick holder holes, and the- 8 9 refore also into the recesses inside the burner. [. . . ]