User manual ZIBRO RCA66

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. Below you will find the main steps to be taken for using your Zibro. º ¾ Ignite the heater using the key (refer to Section D). [. . . ] 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . The light next to them indicates that these numbers The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. Changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to min. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch I: When the KEY-LOCK light lights up, the childproof lock has been activated. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. i) , indicating that the childproof lock has been activated. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. [. . . ] This function can be used when the heater is de-activated also. To switch off the ionizer function, the IONIZER button should be pressed again. Switch off the heater and let it cool down, before you start any maintenance work. also disconnect the plug from the mains. [. . . ]