User manual ZIBRO RS145E

[. . . ] Congratulations on your purchase of this Zibro Kamin heater, the number one brand amongst portable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure themaximum lifetime for your Zibro Kamin heater. [. . . ] The burning can be set up with the flame regulator · If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section G). Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section O) Let the heater burn at its lowest setting (Fig. Then slowly turn the flame regulator · anti-clockwise to its stop. The flame will extinguish after a little while. In case of an emergency, switch off the heater by pushing in the safety button ³ (Fig. If you see a flashing red light in the information display, you should turn off the heater and fill the removable tank. Together with the flashing you will hear a warning signal. After a period of time the combustion may no longer be high enough (Section D). in that case you can adjust the wick height to improve the flame. To do this, the heater must have been switched off. Follow the procedure below: 1 Push in the safety button ³ (Fig. Off the heater, so the wick height lock ¸ will be visible. 3 Take the plastic ring between your thumb and index finger and pull it out. Turn the ring up one step, to either position 2 or 3 (Fig. Carefully push the ring back, so the detent engages in the recess. 4 Carefully reinstall the flame regulator cap. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section J). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick yourself (see chapter O). If the flame gets too high after adjusting (Fig. T), the wick height lock should be placed one position lower again. To avoid odour when igniting the heater, the ventilator should only be turned on when the flame has reached the correct height (Fig. [. . . ] Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. Some drops may leak from the filter; keep a cloth at hand. Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. [. . . ]