User manual ZIBRO S1550

[. . . ] S1523 - S1526 - S1534 S1550 - S1564 4 TR OPERATING MANUAL KULLANIM KILAVUZU 2 20 Dear Sir, Madam, Congratulations on the purchase of your Zibro airconditioner. You have acquired a high quality product that, if used responsibly, will give you many years of pleasure. Please read these instructions for use first in order to ensure the maximum life span of your airconditioner. On behalf of the manufacturer, we provide a 24-month guarantee on all material and production defects. [. . . ] During the heating operation, the outdoor unit may frost and heating capacity may deteriorate. In this case, the unit stops its heating operation and conducts defrosting operation automatically. During the defrosting operation, the fans of the indoor and outdoor units stop. If it is difficult to warm the room because of low outdoor temperature, use additional heating equipment. * For Dual and Triple models only Only one operation mode should be selected at a time for all the indoor units. (Different modes can not be concurrently selected for the indoor units. ) If one or two indoor units are already operating in a certain mode, another mode can not be selected for the other indoor units. A warning beep will sound, and the unit will not function. When this happens, select the same mode as the other operating units. 4 11 Automatic operation In automatic operation the air conditioner selects the operation mode (cooling, dry, heating) according to the room temperature when it starts. The air conditioner will restart in the previous mode if autoHow to select operating mode Heating Dry Cooling Room temperature matic operation is resumed within 3 hours from the switchoff. Mode review The computer checks and compares the room temperature 5 minutes and 15 minutes apart after the compressor shuts off, and it will review the mode. Afterwards it is repeated every 10 minutes. Auto Recovery Function lf there is any power failure during operation, operation status before power failure is memorized. 3~4 minutes after power recover, the unit restarts automatically with previous operation status memorized. (3~4 minutes is protective time for compressor. ) ATTENTION Because of Auto Recovery Function, if shutting off the power supply during operation, the unit may restart irrespective your intention when turning on the power supply next time. If the unit is not to be used for a long time, shut off the power supply after terminating all operation with remote controller. Press the ON/OFF button Set the operation mode to Automatic button. Adjust the setting temperature by pressing the temperature setting button. Temperature setting range:16~30C by 1C step. Adjust the fan speed by pressing the fan speed button. When the mode is set at "AUTO" the fan speed changes automatically. The system will retain the previous setting conditions until next operation. , by pressing the operation mode NOTE If the selected mode by Automatic Operation does not suit you, set the operation mode (cooling, dry heating) with the Operation mode button. Even if you press the ON button after the stop, the air conditioner will not start operation for approx. [. . . ] Then plug in again and push ON/OFF button on the remote control unit. 4 18 H GUARANTEE CONDITIONS The air conditioner is supplied with a 24-month guarantee, commencing on the date of purchase. All material and manufacturing defects will be repaired or replaced free of charge within this period. We expressly refuse all further damage claims, including claims for collateral damage. Repairs to or replacement of components within the guarantee period will not result in an extension of the guarantee. [. . . ]