User manual ZIBRO S1847

[. . . ] Varmetilstand The air conditioner draws in heat from the outdoor unit and releases it via the indoor unit during heating operation. When the outdoor temperature falls, heat drawn in by the air conditioner decreases accordingly. At the same time, heat loading of the air conditioner increases due to larger difference between indoor and outdoor temperature. If a comfortable temperature cannot be achieved by the air conditioner, it is advised to use a supplementary heating device. [. . . ] If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage may damage the remote controller. The average battery life under normal use is about 6 months. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to appear. When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel of the indoor unit starts flashing. Push the v or w button to set the desired room temperature. The most comfortable temperature settings are between 21ºC to 28ºC. Push the On/off button again to stop the unit operation. In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN, HEAT and DRY by sensing the difference between the actual ambient room temperature and the set temperature on the remote controller. If the AUTO mode is not comfortable for you , the desired mode can be selected manually. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY, HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button Push the v or w button ( are 28ºC or below. The operation lamp lights and the air conditioner starts to operate per your again to stop this unit operation. Most comfortable settings are 21ºC or above. When in HEATING mode, the most comfortable settings The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and 4 are applicable. The operation lamp lights and the air conditioner starts to operate in the DRY again to stop this unit operation. Do not adjust the unit to excessive temperature levels. Close doors and windows otherwise the desired effect may be reduced. Use TIMER ON button on the remote controller to select a time you want to start your air conditioner. Do not put any object near air inlet or air outlet, as the efficiency of the air conditioner may be reduced and the air conditioner may stop running. Make sure there are no obstacles blocking the airflow. The air stream must be allowed to reach the entire room unhindered. [. . . ] Power cut Unit may have become unplugged. Unit does not start Remove possible the indoor unit is more than 6 to 7 meters, obstacles. Aim the remote controller or there are obstacles in between the towards the receiver on the indoor unit. The time you have set with timer is incorrect. [. . . ]