User manual ZIBRO SRE 230 E

[. . . ] SRE 230 E 3 2 6 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 12 22 32 42 52 62 AFAQ AFNOR CERTIFICATION 11, AVENUE FRANCIS DE PRESSENSE 93571 SAINT-DENIS LA PLAINE CEDEX FICHE INFORMATIVE La marque NF garantit la qualit de cet article suivant les normes franaises et Rgles de certification de l'application NF 128 CHAUFFAGES MOBILES A COMBUSTIBLE LIQUIDE NF 128 02 / 02 CONFORME A LA NORME NF D 35-300 ET AUX SPECIFICATIONS COMPLEMENTAIRES DEFINIES PAR LES REGLES DE CERTIFICATION DE L'APPLICATION NF 128 PRINCIPALES CARACTERISTIQUES CERTIFIEES: Scurit du dispositif d'allumage Dbit calorifique Efficacit des dispositifs de scurit Stabilit Contrle de la teneur en NOx dans les produits de combustion Contrle de la qualit de la combustion (absence de CO) Endurance Intermittence CONSEILS D'UTILISATION ET D'ENTRETIEN Se reporter la notice jointe l'appareil et la plaque de scurit sur l'appareil Rfrence et numro de lot ou de srie de l'article : se reporter au produit Distributed in Europe by: PVG International B. V. P. O. Box 96, 5340 AB OSS Pays-Bas Tl. : +31 (0) 412 694670 En cas d'insatisfaction, consultez d'abord : En France: PVG France SARL 4, Rue Jean Siblius, B. P. 185 76410 SOTTEVILLE SOUS LE VAL Tl. : 02. 32. 96. 07. 47 Fax: 02. 32. 96. 07. 77 Si une difficult subsistait, vous pouvez crire au LNE LABORATOIRE NATIONAL DE MTROLOGIE ET D'ESSAIS Division Certification plurisectorielle 1, Rue Gaston Boisier - 75724 PARIS CEDEX 15 Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. [. . . ] immediately after that. The TIMER light and the 4-digit 2 Use the adjustment keys to set the time at which the heater must ignite. Use the key on the left (Nhour) to set the hours and the key on the right (Mmin. ) to set the minutes (interval of 5 minutes). 3 After approximately 10 seconds the 4-digit will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. G). G: The TIMER indicator light indicates that the timer function has been switched on. 4 The timer will ensure that the room will have been heated to approximately the required temperature at the set time. G H In case of any malfunctioning the information display will tell you what is the matter. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. SWITCHING OFF THE HEATER There are two ways to switch off the heater. The information display will show the CLOCK signal. Within approximately one minute the flame will have extinguished. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Activate the 'SAVE' I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. setting by pressing the appropriate key. will display on the information display (Fig. Switch off the function by pressing the SAVE key once again. Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. 4 48 K THE 'FUEL' INDICATOR LIGHT When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display (Fig. By pushing this button, the remaining you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION heating time will extend to 60 minutes. The heater will automatically switch J: When the FUEL indicator has appeared, the information display will show the number of minutes of fuel left in the tank. back to its lowest position. In the display the number 60 will appear, which will decline to 10. At the arrival of 10, you will hear an alarm signal every two minutes, warning you to refill the removable tank. If you do not react, the heater will extinguish by itself. [. . . ] Do not move the heater when it is burning or still hot. Do not refill nor service the heater when it is burning or still hot. Position the front of the heater at a distance of minimum 1. 5 metres from walls, curtains, and furniture. You will not have optimum burning in such rooms. [. . . ]