User manual ZIBRO SRE153

[. . . ] Congratulations with your purchase of a portable domestic heater. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your heater. [. . . ] The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start blinking). ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key will start blinking. The TIMER light and the 4-digit 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the 4-digit will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display not only serves as an indicator of the (set) time and temperature (sections C, E, and F), it also indicates any malfunctioning of the heater. In case of any malfunctioning the information display will tell you what is the matter. INFORMATION Temperature within the heater too high. The heater has been in operation continuously for a period of 48 hours and has turned itself off automatically. Always contact your dealer for any malfunctioning not listed above. This heater is fitted with a safety system that ensures that it switches off automatically after 48 hours continuous operation. [. . . ] Your heater needs hardly any maintenance. It is, however, important that you clean the air filter ¾ and the vent With a damp cloth, both on a L) and clean it with soapy water. Some drops may leak from the filter; keep a cloth at hand. 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. [. . . ]