User manual ZIBRO SRE166

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your heater. Yours sincerely, PVG International b. v. Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 42 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. For more details, please refer to the MANUAL (pages 45 ff. ). MAIN COMPONENTS Front plate Grid Base plate Lid for removable 1 2 3 4 5 Remove all packaging materials (refer to Section A, Fig. tank Fill the removable tank (refer to Section B, Fig. [. . . ] Never use matches or a cigarette lighter. The button will start blinking, button will remain lit (red). The information display Just press the indicating that the ignition procedure has started. Once the heater is burning, the will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). Prior to igniting the heater, always check for sufficient fuel in the removable tank. E SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start blinking). Next, adjust min. ) to set the temperature to a switch on the function (the C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( hour) to lower the temperature. Too little ventilation. Always contact your dealer for any malfunctioning not listed above. AUTOMATIC DEACTIVATION This heater is fitted with a safety system that ensures that it switches off automatically after 48 hours continuous operation. The following will then appear in the display: the button . If desired, you can switch the heater on again by pressing (see section D). AUTOMATIC CLEANING MODE When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. The display will show the autocleaningcode cl 05 running back to cl 00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I CHILDPROOF LOCK The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. ) will appear on the H: When the mark appears, the childproof lock has been activated. information display (Fig. [. . . ] The use of incorrect fuel can even be dangerous*. 7 Transportation costs and the risks involved during the transportation of the heater or heater components shall always be at the expense of the purchaser. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. [. . . ]