User manual ZIBRO SRE176

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your heater. Below you will find the main steps to be taken for using your heater. ² ¶ Ignite the heater using the key (refer to Section D). [. . . ] Once the heater is burning, the will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start blinking). ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key will start blinking. The TIMER light and the 4-digit 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. And holding it down for more I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE key once again. Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. [. . . ] Some drops may leak from the filter; keep a cloth at hand. Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 1 We expressly dismiss all other claims for damages, including consequential damages. [. . . ]