User manual ZIBRO SRE185

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro Kamin. Below you will find the main steps to be taken for using your Zibro Kamin. ² ¶ Ignite the heater using the key (refer to Section D). [. . . ] When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the lighter. Once the heater is burning, the information display ¹ will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to min. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaning code cl:05 running back to cl:00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I: When the KEY-LOCK light lights up, the childproof lock has been activated. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. i) , indicating that the childproof lock has been activated. [. . . ] ) 3 Reinstall the fuel filter into the heater. We recommend that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Do not remove any heater components yourself. Always contact your Zibro Kamin dealer for repairs. [. . . ]