User manual ZIBRO SRE188E

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. Below you will find the main steps to be taken for using your Zibro. If required, change the temperature using the adjustment keys (refer to Section E). [. . . ] When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . Once the heater is burning, the will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start blinking). ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key down for more than 3 seconds. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. And holding it down for more I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE key once Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. [. . . ] 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. ) 3 Reinstall the fuel filter into the heater. We recommend that you remove dust and stains from time to time with a damp cloth, because otherwise these may cause stains that are hard to remove. Do not remove any heater components yourself. [. . . ]