User manual ZIBRO SRE270TC

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your heater. Yours sincerely, PVG International b. v. Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 42 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. For more details, please refer to the MANUAL (pages 45 ff. ). MAIN COMPONENTS Front plate Grid Base plate Lid for removable 1 2 3 4 5 Remove all packaging materials (refer to Section A, Fig. tank Fill the removable tank (refer to Section B, Fig. [. . . ] 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. D F: The required temperature on the left, the measured temperature on the right. When the heater has been unplugged (or after a power failure), the time needs to be set again. IGNITING THE HEATER When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . Never use matches or a cigarette lighter. Just press the button to ignite the heater. The POWER lamp will start blinking, indicating that the ignition procedure has started. Once the heater is burning, the POWER lamp will remain lit (red). The information display will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The following will then appear in the display: the . If desired, you can switch the heater on again by pressing button (see section D). AUTOMATIC CLEANING MODE When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. The display will show the autocleaningcode cl 05 running back to cl 01. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I CHILDPROOF LOCK The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it H: When the mark appears, the childproof lock has been activated. down for more than 3 seconds. The KEY-LOCK indicator Switch off the childproof lock by pressing the key than 3 seconds once again. will appear on the information display (Fig. H), indicating that the childproof lock has been activated. and holding it down for more 4 48 J I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. THE CORRECT USE OF 'SAVE' The 'SAVE' function allows you to limit the temperature. [. . . ] The use of incorrect fuel can even be dangerous*. 7 Transportation costs and the risks involved during the transportation of the heater or heater components shall always be at the expense of the purchaser. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. Should this happen, never try to move the heater, but always switch off the heater immediately. [. . . ]