User manual ZONET ZEW2542

[. . . ] Copyright Statement is the registered trademark of Zonet Technology Inc. All the products and product names mentioned herein are the trademarks or registered trademarks of their respective holders. Copyright of the whole product as integration, including its accessories and software, belongs to Zonet Technology Inc. Without the permission of Zonet Technology Inc. , any individual or party is not allowed to copy, plagiarize, imitate or translate it into other languages. All the photos and product specifications mentioned in this manual are for references only. [. . . ] Protocol: Select the protocol of tunneled authentication. This pull-down menu is only available when authentication type is using PEAP or TTLS. When using EAP-FAST as authentication type, the protocol setting is always Generic Token Card and can not be changed. Password Mode: Select the password mode of EAP-FAST authentication mode. This setting is hidden when the authentication type is not EAP-FAST. 11 802. 11n Wireless USB Adapter 4. 2 Link Status Link status page shows detail information about the current connection. 1. Status: Shows the current connected SSID / BSSID. If there's no active connection currently, "Disconnected" will be displayed. Extra Info: Shows link status and its transmit power 3. Channel: Shows the current connected channel 4. Link Quality: Based on signal strength and TX/RX packet error rate (%) 5. Signal Strength: Shows in percentage (%) or dBm 6. Noise Level: Shows noise and signal strength ratio (%). If the value of this item is high, data transfer rate will drop. Transmit: Link Speed: Shows current transmitting rate (Mbps) Throughput: Shows current transmitting throughput (Kbps) 8. 8. WPS AP List: Display the information of surrounding APs with WPS IE from last scan result, including SSID, BSSID, Channel, ID (Device Password ID), Security-Enabled. Rescan: Update information on surrounding wireless network. Information: Display the information about WPS IE on the selected network, list including Authentication Type, Encryption Type, Config Methods, Device Password ID, Selected Registrar, State, Version, AP Setup Locked, UUID-E and RF Bands PIN Code: 8-digit numbers. Config Mode: Enrollee or external Registrar Detail: Information about Security and Key in the credential. Connect: Connect to the selected network inside credentials. Rotate: Connect to the next network inside credentials. 17 802. 11n Wireless USB Adapter 9. 13. Disconnect: Stop WPS action and disconnect this active link. Export Profile: Export all credentials to Profile. [. . . ] Please note that it might be necessary to set up one client to establish a BSS (Basic Service Set) and wait briefly before setting up other clients. This prevents several clients from trying to establish a BSS at the same time, which can result in multiple singular BSSs being established, rather than a single BSS with multiple clients associated to it. Check that the Network Connection for the wireless client is configured properly. If Security is enabled, make sure that the correct encryption keys are entered on both ZEW2542 and the access point. 28 802. 11n Wireless USB Adapter 4. [. . . ]