User manual ZONET ZFS3124 QUICK INSTALLATION GUIDE

[. . . ] 16 /24 port 10/100 Switch Quick Installation Guide 16 / 24-port 10/100 Ethernet Switch Introduction The 16/24 port Ethernet Switch are designed to allow simultaneous transmission of multiple packets via an internal high-speed data channel. This means that it can partition a network more efficiently than bridges or routers in most environments . This 16/24 port Ethernet Switch is a highly reliable network Switch and is the ideal device for bridging Ethernet to Fast Ethernet workgroups or networks . Simple and cost-effective, the 16/24 port Switch Ethernet supports IEEE802. 3 10Base-T Ethernet and IEEE802. 3u 100Base-TX Fast Ethernet. [. . . ] Connect other IEEE802. 3 compatible network device(Hub , Switch , PC) to one port of the 16/24 port Switch using Category 3/4/5 UTP/STP cabling. Connect another IEEE802. 3 compatible network device (Hub , Switch , PC) to another port of 16/24 port Switch by following the same process as described in Step3. Notice: The cable distance between 16/24 port Switch and other IEEE802. 3 compatible network device should not exceed 100 meter. Make sure the wiring is correct It can be used Category 3/4/5 cable in 10 Mbps operation. To reliably operate your network at 100Mbps, you must use an Unshielded/Shielded Twisted-Pair (UTP/STP) Category 5 cable, or better Data Grade cabling. While a Category 3 or 4 cable may initially seem to work, it will soon cause data loss. All kinds of IEEE802. 3 compatible network device (Hub , Switch , PC)can connect to Switch by using straight-through wires or crossover wires because of Switch's auto MDIX function. 1-4 Installation 16 / 24-port 10/100 Ethernet Switch Troubleshooting If the 16/24 port Switch is not functioning properly, make sure the 16/24 port Switch was set up according to instructions in this manual. Check if the AC power cord is well connected. Try to unplug and plug back the power cord to the LAN Switch or try another power cord. Check if the AC power source is in good condition. Make sure the Switch configuration is consistent with the connecting device c. Make sure the cable distance between 16/24 port Switch and other IEEE802. 3 compatible network device should not exceed 100 meter. Check the full duplex status of the Ethernet Switching. [. . . ] Make sure that the workstation's network configuration is correct, modify the network configuration of workstation if need. Please reset the switch if need. 1-5 Trouble Shooting [. . . ]