User manual ZONET ZSR0104CP

[. . . ] Cable/DSL Broadband Router w/4-Port Switch 1. Introduction 1. 1 Features 1. 2 Package Contents 2. Appearance Illustration 2. 1 Panel 2. 1. 1 Front Panel 2. 1. 2 Rear Panel 2. 2 Illustration 2. 3 Illustration of router Indicators 2. 4 Working environment 3. Setup your computer 3. 1 Connect the Router 3. 2 Windows 98/Me 3. 3 Windows 2000 3. 4 Windows XP 3. 5 Windows Vista/7 4. [. . . ] When finished making your changes on this screen, click the Save button to save these changes. 26 Cable/DSL Broadband Router w/4-Port Switch 4. 4 Routing If the Router is connected to more than one network, it may be necessary to set up a static route between them. A static route is a pre-determined pathway that network information must travel to reach a specific host or network. Figure 4-11 Type / Target / Mask / Gateway: Fill in these fields required by this Static Routing function. Add: Click this button to add a new static routing. When you click this button, the next figure appears. Current Routing Table: This display shows the valid routing paths in Broadband Router. User can view the information about current routing paths Fill in the all of the setting to be added and then click "Add". Then this Special Application setting will be added into the "Current Routing Table" below. If you want to remove some Special Application settings from the " Current Routing Table ", select the Special Application settings you want to remove in the table and then click "Delete ". When finished making your changes on this screen, click the Save button to save these changes. 4. 5 NAT Network Address Translation (NAT) allows multiple users at your local site to access the Internet through a single Public IP Address. NAT provides Firewall protection from hacker attacks and has the flexibility to allow you to map Private IP Addresses to Public IP Addresses for key services such as Websites and FTP. When finished making your changes on this screen, click the Save button to save these changes. 27 Cable/DSL Broadband Router w/4-Port Switch 4. 5. 1 DMZ Host Setup The DMZ screen allows one local user to be exposed to the Internet for use of a special-purpose service such as Internet gaming and videoconferencing. DMZ hosting forwards all the ports for one PC at the same time. Figure 4-12 Check DMZ and enter the host IP and then press "Apply" button to setup DMZ host. When finished making your changes on this screen, click the Save button to save these changes. 4. 5. 2 FTP Private Port FTP private port enables user to setup FTP server which is not using the standard port 21. Figure 4-13 Check port number and enter the number and then press the "Apply" button to setup Private FTP port. When finished making your changes on this screen, click the Save button to save these changes. 4. 5. 3 Virtual Server Setup User can specify some services to be visible from outside users. The router can detect incoming service request and forward it to the specific local computer to handle it. For example, user can assign a PC in LAN acting as WEB server inside and expose it to the outside network. Outside user can browse inside web server directly while it is protected by NAT. 28 Cable/DSL Broadband Router w/4-Port Switch Figure 4-14 Rule Name: The description of this setting. Internal Server IP Address: This is the LAN client/host IP address that the Public Port number packet will be sent to. Protocol: Select the protocol type (TCP, UDP, FTP, HTTP). [. . . ] When the physical connection is correct, the Power light and the CPU light should be solid , the WAN light should be blinking. If you use your computer, the corresponding LAN port light should be blinking too. If not, please check whether the cables work or not. If cables work, please follow the steps in 11. 1 Forget Password (Reset the Router without Login) to reset the Router. [. . . ]