User manual ZONET ZSR1134WE

[. . . ] Copyright Statement is the registered trademark of Zonet Technology Inc. All the products and product names mentioned herein are the trademarks or registered trademarks of their respective holders. Copyright of the whole product as integration, including its accessories and software, belongs to Zonet Technology Inc. Without the permission of Zonet Technology Inc. , any individual or party is not allowed to copy, plagiarize, imitate or translate it into other languages. Table of Contents Chapter 1 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Beacon Interval The interval of time ZSR1134WE broadcast a beacon. Beacon is used to synchronize the wireless network. Data Rate For different requirement, you can select one of the suitable Basic Data Rates. Preamble Type Long Preamble can provide better wireless LAN compatibility Short Preamble can provide better wireless LAN performance Broadcast SSID Enabled: Every wireless station located within the coverage of ZSR1134WE can discover it easily. IAPP Enabled IAPP allows wireless station roaming between IAPP enabled routers within the same wireless LAN. 802. 11g Protection It also called CTS Protection. It is recommended to enable the protection mechanism. This mechanism can decrease the rate of data collision between 802. 11b and 802. 11g wireless stations. When the protection mode is enabled, the throughput of ZSR1134WE will be a little lower due to many of frame traffic should be transmitted. 21 Security Setup a. WEP (Set WEP Key) WEP (Wired Equivalent Privacy) is an encryption method used to protect your wireless data communications. WEP uses a combination of 64-bit or 128-bit keys to provide access control to your network and encryption security for every data transmission. Key Length Select the WEP Key Length from 64-bit or 128-bit. Larger WEP key length will provide higher level of security, but the throughput will be lower. Key Format ASCII: Use any alphanumerical characters (0-9, a-z, and A-Z) Hex: Use characters 0-9, a-f, and A-F. Default Key Select one of the four keys to encrypt your data. Only the key you select it in the Default key will take effect. Encryption Key 1, 2, 3, 4 Input WEP key characters here, the number of characters must be the same as the number displayed at Key Format. Rules: 64-bit WEP: Input 10-digit Hex values or 5-digit ASCII character 128-bit WEP: Input 26-digit Hex values or 13-digit ASCII characters. 23 c. 802. 1x This security mode is used when a RADIUS server is connected to ZSR1134WE. IEEE 802. 1x is an authentication protocol. Every user must use a valid account to login to ZSR1134WE before accessing the wireless LAN. The authentication is processed by a RADIUS server. This mode also uses WEP to encrypt the data during communication. Authentication RADIUS Server Port Input the port number of the Radius server here. [. . . ] The default user name/password is guest. Q3. I have some problems related to Connection with Cable Modem Please follow the steps to check the problems: Check whether the DSL modem works well or the signal is stable. Normally there will be some indicator lights on the modem, users can check whether the signal is ok or the modem works well from those lights. Check the front panel of ZSR1134WE, there's also some indicator lights there. [. . . ]