User manual ZONET ZSR4154WE

[. . . ] Copyright Statement is the registered trademark of Zonet Technology Inc. All the products and product names mentioned herein are the trademarks or registered trademarks of their respective holders. Copyright of the whole product as integration, including its accessories and software, belongs to Zonet Technology Inc. Without the permission of Zonet Technology Inc. , any individual or party is not allowed to copy, plagiarize, imitate or translate it into other languages. Table of Contents Chapter 1 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Two minutes later, the WPS indicator will be off. 26 PIN: if you want to use PIN code, you have to know the PIN code of wireless client and switch it to WPS mode, then provide the PIN code of the wireless client you wish to connect to ZSR4154WE. WPS Current StatusIdle means WPS in idle state. Start MSC process means the process has been started and waits for being connected. Configured means the negotiation is successful between server and clients. WPS Configured Yes means WPS feature is enabled and goes into effect. Usually the AP-security has been enabled will displayed No. ModeThe authorization mode deployed by WPS, generally WPA/WPA2-personal mode. WPS Encrypt Type The encryption type used by WPS, generally AES/TKIP. WPS keyThe effective key generated by AP automatically. AP PINKEY The PIN code used by default. Reset OOB When the button is pressed, the WPS client will be idle state, and WPS indicator will be turned off. ZSR4154WE will not respond the WPS client's requests and the set the security mode as WPA mode. WDS Settings In this mode, you can expand the scope of network by combining up to four other access points together, and every access point can still accept wireless clients. 27 WDS Mode: Lazy Mode: You need to configure ZSR4154WE's BSSID into another device, but don't need to input another device's BSSID in ZSR4154WE, and they will connect together automatically. Bridge Mode: You can wirelessly connect two or more wired networks via this mode. In this mode, you need to add the Wireless MAC address of the connecting device into ZSR4154WE's AP MAC address table or select one from the scanning table. At the same time, the connecting device should be in Lazy, Repeater or Bridge mode. Repeater Mode: You can select the mode to extend the distance between the two WLAN devices. Functioning as a WDS repeater, ZSR4154WE connects to both a client card as an AP and to another AP. In typical repeater applications, APs connecting to other APs equipped with WDS functionality must also support WDS. In this mode, you need to add the MAC address of the connecting device into ZSR4154WE's AP MAC address table and the connecting client should be in Lazy, Repeater or client mode. Encrypt Type: You can select from WEP mode, TKIP mode, AES mode for security here. Pass phrase: Enter the key, the key format according to encryption you selected. AP MAC: Input the MAC address of another wireless router. NOTE: Two wireless routers must use the same band, channel number, and security setting. Access Control This function will help you to prevent unauthorized users from connecting to ZSR4154WE; only those wireless devices who have the MAC address you assigned here can gain access to your ZSR4154WE. [. . . ] I can not use E-mail and access the Internet. It happens in ADSL connection and Dynamic IP users. And you need modify the default MTU value (1492). Please in the "WAN Setting" modify the MTU value with the recommended value as 1450 or 1400. 48 Q5. [. . . ]