User manual ZOOM PLUG-IN

[. . . ] A dialog box such as shown above will appear three times. If a software installation warning dialog box is shown, click [Continue]. If a Windows Security message indicating that the driver software publisher cannot be verified appears, click [Install this driver]. * In this case, the message "ZOOM S2t C5. [. . . ] Jp © ZOOM Corporation Reproduction of this manual, in whole or in part, by any means, is prohibited. zFX-Hardware-E-1 HARDWARE MANUAL Controls and indicators of S2t CH1[TUBE] knob PHANTOM[ON/OFF] switch CH1[SOLIDSTATE] knob CH2[PEAK] indicator [OUTPUT] knob * Available only for CH2[GAIN] knob [PHONES] knob Hi-Z jack. [DIRECT MONITOR] knob CH1[PEAK] indicator [MONO/STEREO] switch Connections and Functions 9 Rhythm machine 6 Monitor System (Audio component/ Amplified speaker) 1 Guitar/Bass Connect your guitar/bass to the Hi-Z jack with a monaural shielded cable. To enable the Hi-Z input, turn the INPUT SELECT [Hi-Z/MIC/LINE] switch at the front panel to "Hi-Z" CH/R jack. XLR plugs, stereo phone plugs (balanced), and monaural phone plugs (unbalanced) can be connected. to enable , turn the INPUT SELECT [Hi-Z/MIC/LINE]switch to "MIC". Phantom power might be supplied to the condenser microphones with turning on the PHANTOM [ON/OFF] switch. 7 Dynamic microphone and condenser microphone 2 Headphone 2 Headphone Headphones should be connected to the PHONES jack, and its volume can be adjusted with [PHONES]knob. 2kg [PHONES] knob CH1 [SOLIDSTATE] knob Headphone volume can be adjusted with [PHONES] knob. The input signals from Hi-Z and MIC INPUT CH1/L jacks can be gained with CH1 [SOLIDSTATE] knob. CH1 [PEAK] indicator lights on when the signal is too large. With these knobs, you can mix the tube gained sound and the transistor gained sound for the guitar/bass inputs. [OUTPUT] knob Output volume of the output jacks can be adjusted with [OUTPUT] knob. •Headphone *0 dBm = 0. 775 Vrms *Design and specifications subject to change without notice. INPUT SELECT [Hi-Z/MIC/LINE] switch CH2 [GAIN] knob The MIC INPUT CH2/R jack input can be gained with CH2 [GAIN] knob. CH2 [PEAK] indicator lights on when the signal is too large. This switches the available input jacks. When the Hi-Z jack is on use, switch this to "Hi-Z". As well, "MIC" is for MIC INPUT jacks, and "LINE" is for line input jacks. G Residual Noise Level •MIC Input [MONO/STEREO] switch This switches the direct monitor sound between monaural and stereo. [DIRECT MONITOR] knob The input sounds to Hi-Z, MIC INPUT and other jacks can be sent to OUTPUT L(MONO)/R and PHONES jacks to get PHANTOM [ON/OFF] switch •LINE INPUT To supply the phantom power to a condenser microphone, turn on the PHANTOM [ON/OFF] switch. [. . . ] To stop recording, click the Stop button in the transport panel. Channel assigned to audio track Master channel To play the recording, perform the following steps. While playing your instrument, adjust the output level of this unit to achieve a suitable recording level for Cubase LE 4. Move the fader of the master channel (as displayed in step 13) fully down. [. . . ]