User manual ZOTAC H77-ITX WIFI SUPREME

[. . . ] Never insert objects of any kind into the ventilation openings. ™™ Use this product in environments with ambient temperatures between 0℃ and 35℃. , If you use an extension cord, please use the UL listed cord and make sure that the total ampere rating of the devices plugged into the extension cord does not exceed its ampere rating. Care during use ™™ Do not walk on the power cord or allow anything to rest on it. ™™ Do not spill water or any other liquids on your system. [. . . ] Do not cover the adapter and keep it away from your body. Note 2: Due to the special design for easy upgrade, some connectors are placed upside down. 6 ZOTAC ZBOX nano Rear view 1 3 5 7 9 2 4 6 8 Refer to the diagram below to identify the components on this side of the system. Power input (DC19V) The supplied power adapter converts AC power to DC power for use with this jack. Power supplied through this jack supplies power to the mini-PC. To prevent damage to the mini-PC, always use the supplied power adapter. HDMI output The HDMI (High Definition Multimedia Interface) output supports Full HD 1080p displays such as an HDTV or monitor. DisplayPort DisplayPort supports both external (box-to-box) and internal (laptop LCD panel) display connections. USB 3. 0 ports The USB 3. 0 ports support the SuperSpeed USB 3. 0 devices and are backwards compatible with USB 2. 0/1. 1 devices. Use the ports for USB 3. 0 devices for maximum performance with USB 3. 0 compatible devices. Ethernet port The eight-pin RJ-45 LAN port supports standard Ethernet cable for connection to a local area network (LAN) with speeds of 10/100/1000Mbps. Connecting USB 2. 0 device Connect USB 2. 0 devices like wired/wireless keyboards (varying with areas), mouse devices and printers to the USB 2. 0 ports. Connecting a WiFi antenna module Connect a WiFi antenna module to the WiFi antenna connector. 16 ZOTAC ZBOX nano 5 6 7 8 5. Turning on the system Connect the supplied AC adapter to the DC IN jack on the system rear panel and then press the power switch on the front panel to turn on the system. Connecting to an HDMI display Connect one end of an HDMI cable to the HDMI port on the system rear panel and the other end to a HDMI-compatible display such as an HDTV or monitor. (When both the HDMI and the DP are connected, the audio output is from HDMI by default. ) 7. Connecting to a home network Connect one end of a network cable to the LAN port on the system rear panel and the other end to a network hub, switch or router. If the hardware equipments you adopt are not compatible with the system, you are unable to use these functions. The ZOTAC ZBOX nano is designed to meet MCE standards. 20 ZOTAC ZBOX nano Lithium cell installation  1. Locate the arrow on the rear cover of the remote control, and push the cover as the arrow direction. 2. Remove the rear cover, and insert the CR2032 lithium cells into the battery jar at a 45 degree angle. 3. Gently press down on the CR2032 lithium cells, and reinstall the rear cover. 21 ZOTAC ZBOX nano Installing drivers and software Installing an operating system The ZOTAC ZBOX nano does not ship with an operating system preinstalled. [. . . ] 7. After entering all of the related values, click “OK” to finish the configuration. 23 ZOTAC ZBOX nano Using a dynamic IP (PPPoE connection) 1. 2. 3. 4. 5. 6. Repeat Step 1-3 in the previous section. Select “Obtain an IP address automatically” and click “OK”. Click “Create a new connection” to start the NEW Connection Wizard. Select “Connect to the Internet” and click “Next”. [. . . ]