User manual ZOTAC ZBOX ID-81 PLUS

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - - - - REORIENT OR RELOCATE THE RECEIVING ANTENNA INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND THE RECEIVER CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT OF THE RECEIVER CONSULT THE DEALER OR AN EXPERIENCED AUDIO/TELEVISION TECHNICIAN NOTE: Connecting this device to peripheral devices that do not comply with Class B requirements, or using an unshielded peripheral data cable, could also result in harmful interference to radio or television reception. The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables. Copyright This manual is copyrighted with all rights reserved. [. . . ] Detailed descriptions of the BIOS parameters are also provided. The BIOS is the communication bridge between hardware and software. Correctly setting the BIOS parameters is critical to maintain optimal system performance. Refer to the following procedure to verify/change BIOS settings. 2. Press the Del key when the following message briefly displays at the bottom of the screen during the Power On Self Test (POST). Pressing Del takes you to the BIOS Setup Utility. Note: 1. We reserve the right to update the BIOS version presented in the manual. The BIOS pictures shown in this section are for reference only. It is strongly recommended that you do not change the default BIOS settings. Changing some settings could damage your system. Main Menu This menu gives you an overview of the general system specifications. The BIOS automatically detects the items in this menu. Note: Users please note that the data in gray is non-changeable, and the others are for selection. q BIOS Information Displays the auto-detected BIOS information. 17 Intel NM70-ITX series Motherboard q q q q Processor Information Displays the auto-detected processor information. Press <Enter> to display the configuration options: q Deep S5 When enabled, wake up from S5 can only be done by power button. q Restore AC Power Loss This item allows you to configure how the system board responds to a power failure. q Wake Up by USB KB/Mouse from S3 Enable or disable wake up by USB/PS2 KB/Mouse from S3. q Wake Up by PS2 KB/Mouse from S3/S4/S5 Enable or disable wake up by PS2 KB/Mouse from S3/S4/S5. q Wake Up on Alarm Enable or disable wake up on alarm. q Wake Up by PCIE Device from S3/S4/S5 Enable or disable wake up by PCIE device from S3/S4/S5. Display Configuration The items in this menu allow you to set display Configuration. q Aperture Size This item allows you to set the aperture size, options: 64MB/128MB/256MB. q DVMT Pre-Allocated This item allows you to set DVMT pre-allocated size. q DVMT Total Gfx Mem This item allows you to set DVMT total Gfx mem size. OnBoard Device Configuration The items allow you to configure onboard device, including HD Audio, LAN and so on. q LAN1/2 Controller Enable or disable onboard LAN1/2 controller. 20 Configuring the BIOS q USB 3. 0/2. 0 Controller Enable or disable USB 3. 0/2. 0 controller. q HD Audio Controller Enable or disable HD Audio controller. Network Stack The item in this menu allows you to set network stack. [. . . ] The driver installation pictures shown in this section are for reference only. The kit comes with a driver disk that contains utility drivers and additional software. The driver disk that has been shipped with your motherboard contains the following software and drivers: q Intel Chipset Driver q HDA Sound Driver q Intel Graphics Driver q Ethernet PCI-E Driver q USB3. 0 Controller Driver q Intel Management Engine q Intel(R) Rapid Storage Technol Drivers Installation 1. Insert the driver disk into the drive after loading your operating system, and then you can see the interface below. 27 Intel NM70-ITX series Motherboard 2. [. . . ]