User manual ZYXEL G-202

[. . . ] ZyXEL G-202 802. 11g Wireless USB Adapter User's Guide Version 2. 00 Edition 1 5/2007 ZyXEL G-202 User's Guide Copyright Copyright © 2007 by ZyXEL Communications Corporation. The contents of this publication may not be reproduced in any part or as a whole, transcribed, stored in a retrieval system, translated into any language, or transmitted in any form or by any means, electronic, mechanical, magnetic, optical, chemical, photocopying, manual, or otherwise, without the prior written permission of ZyXEL Communications Corporation. Published by ZyXEL Communications Corporation. All rights reserved. Disclaimer ZyXEL does not assume any liability arising out of the application or use of any products, or software described herein. [. . . ] Enter a passphrase of up to 63 case-sensitive printable characters. As you enter the passphrase, the G-202 automatically generates four different WEP keys and displays it in the key field below. Refer to Section 3. 2. 3. 1. 1 on page 35 for more information. At the time of writing, you cannot use passphrase to generate 256-bit WEP keys. Select a default WEP key to use for data encryption. DESCRIPTION Transmit Key 46 Chapter 4 Wireless Station Mode Configuration ZyXEL G-202 User's Guide Table 6 Station Mode: Security Setting: WEP (continued) LABEL DESCRIPTION Key x (where x is a Select this option if you want to manually enter the WEP keys. Enter the WEP key number between 1 in the field provided. and 4) If you select 64 Bits in the WEP field. Enter either 10 hexadecimal digits in the range of "A-F", "a-f" and "0-9" (for example, 11AA22BB33) for HEX key type. or Enter 5 ASCII characters (case sensitive) ranging from "a-z", "A-Z" and "0-9" (for example, MyKey) for ASCII key type. If you select 128 Bits in the WEP field, Enter either 26 hexadecimal digits in the range of "A-F", "a-f" and "0-9" (for example, 00112233445566778899AABBCC) for HEX key type or Enter 13 ASCII characters (case sensitive) ranging from "a-z", "A-Z" and "0-9" (for example, MyKey12345678) for ASCII key type. If you select 256 Bits in the WEP field, Enter either 58 hexadecimal digits in the range of "A-F", "a-f" and "0-9" (for example, 0000111122223333444455556666777788889999AAAABBBBCCCC000011) for HEX key type or Enter 29 ASCII characters (case sensitive) ranging from "a-z", "A-Z" and "0-9" (for example, MyKey111122223333444455556678) for ASCII key type. Note: The values for the WEP keys must be set up exactly the same on all wireless devices in the same wireless LAN. ASCII WEP keys are case sensitive. Back Next Exit Click Back to go to the Site Survey screen to select and connect to another network. Click Next to confirm your selections and advance to the Confirm Save screen. Click Exit to return to the Site Survey screen without saving. 4. 3. 1. 2 WPA-PSK/WPA2-PSK Figure 26 Station Mode: Security Setting: WPA-PSK/WPA2-PSK Chapter 4 Wireless Station Mode Configuration 47 ZyXEL G-202 User's Guide The following table describes the labels in this screen. Table 7 Station Mode: Security Setting: WPA-PSK/WPA2-PSK LABEL Encryption Type DESCRIPTION The encryption mechanisms used for WPA/WPA2 and WPA-PSK/WPA2-PSK are the same. The only difference between the two is that WPA-PSK/WPA2-PSK uses a simple common password, instead of user-specific credentials. Select the encryption type (TKIP or AES) for data encryption. Refer to Section 3. 2. 3. 3 on page 36 for more information. Type a pre-shared key (same as the AP or peer device) of between 8 and 63 casesensitive ASCII characters (including spaces and symbols) or 64 hexadecimal characters. Click Back to go to the Site Survey screen to select and connect to another network. Click Next to confirm your selections and advance to the Confirm Save screen. Click Exit to return to the Site Survey screen without saving. Pre-Shared Key Back Next Exit 4. 3. 1. 3 WPA/WPA2 Figure 27 Station Mode: Security Settings: WPA/WPA2 The following table describes the labels in this screen. Table 8 Station Mode: Security Setting: WPA/WPA2 LABEL Encryption Type DESCRIPTION The encryption mechanisms used for WPA/WPA2 and WPA-PSK/WPA2-PSK are the same. [. . . ] In TCP/IP Gateway Address, type the IP address of the default gateway in Gateway. To manually configure a default metric (the number of transmission hops), clear the Automatic metric check box and type a metric in Metric. Repeat the previous three steps for each default gateway you want to add. Click OK when finished. · · · 7 In the Internet Protocol TCP/IP Properties window (the General tab in Windows XP): Appendix E Setting up Your Computer's IP Address 103 ZyXEL G-202 User's Guide · · Click Obtain DNS server address automatically if you do not know your DNS server IP address(es). [. . . ]