User manual ZYXEL G-3000H

[. . . ] 1 In Windows XP, click Start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel. 2 In Windows XP, click Network Connections. In Windows 2000/NT, click Network and Dial-up Connections. [. . . ] Select Disable to turn off WEP data encryption. Select ASCII or HEX WEP key input method and then follow the on-screen instructions to set up the WEP keys. 3 Fill in the fields in the last wizard configuration screen. If you have an IP address to use, select Use fixed IP address and enter it along with the subnet mask and gateway IP address. Click Finish. Note: If you change the ZyAIR's IP address, you must use the new IP address if you want to access the web configurator again. 7 G-3000H Quick Start Guide 4 Change the wireless parameter settings in the wireless stations to match those of the ZyAIR. Refer to your wireless adapter's documentation. You may return to the MAIN MENU and continue to configure your ZyAIR. 4 Hardware Installation 4. 1 Attaching Antennas Note: When facing the front of the ZyAIR, the right antenna (main antenna) transmits and receives, the left antenna only receives. Follow the steps below to connect the supplied antennas. 1 Locate the antenna connectors on the sides of your ZyAIR. 2 Screw the antennas clockwise onto the antenna connectors. The antennas should be perpendicular to the ground and parallel to each other. Note: Make sure the antennas are securely screwed onto the antenna connectors. 4. 2 Hardware Mounting Installation In general, the best location for the access point is at the center of your intended wireless coverage area. For better performance, mount the ZyAIR high up free of obstructions. 8 G-3000H Quick Start Guide Free-standing Place your ZyAIR on a flat, level surface (on a desk or shelf) that is strong enough to support the weight of the ZyAIR with connection cables. Wall-mounted Follow the steps to attach your ZyAIR to a wall. 1 Locate a high position on the wall that is free of obstructions. 2 Connect two screws (not included) in the wall 60mm apart. You can use the diagram at the end of this guide to help you mark the screw holes correctly. Use screws with 6mm ~ 8mm (0. 24" ~ 0. 31") wide heads. Do not screw the screws all the way in to the wall. Leave a small gap between the head of the screw and the wall. The gap must be big enough for the screw heads to slide into the screw slots and the connection cables to run down the back of the ZyAIR. Note: Make sure the screws are securely fixed to the wall and strong enough to hold the weight of the ZyAIR with the connection cables. 3 Adjust the cables. Run the connection cables down the back of the ZyAIR as shown in the following figure. OR: Run the connection cables upward and along the edge of the ceiling. 9 G-3000H Quick Start Guide 4 Align the holes on the back of the ZyAIR with the screws on the wall. Hang the ZyAIR on the screws. 5 Power over Ethernet (PoE) Power over Ethernet (PoE) is the ability to provide power to your ZyAIR via an 8-pin CAT 5 Ethernet cable, eliminating the need for a nearby power source. [. . . ] If you have changed the password and have now forgotten it, you will need to reset the ZyAIR. Refer to the User's Guide for how to use the RESET button. Make sure the ZyAIR is connected to the network. Make sure you entered your username correctly. [. . . ]