User manual ZYXEL G-470

[. . . ] · Windows 98 SE users may need the Windows 98 SE CD. 2 Hardware Connections Figure 1 The G-470: Rear Panel The following table describes the rear panel of the G-470. Label 1 2 3 4 Description Antenna connector RESET button ETHERNET port POWER socket Follow the steps below to install the G-470 in your computer. 1 Screw the antenna clockwise onto the antenna connector. [. . . ] The light is The device is not ready, or is blinking orange. The power is off. If any of these lights are not on, check your connections and inspect your cables for damage. If the lights are still off, contact your local vendor. Internet Setup You must first prepare your computer / computer network to connect to the G-470 by setting up your IP address. 1 Click start (Start in Windows 2000/NT) > Settings > Control Panel. 6 2 In the Control Panel, double-click Network Connections (Network and Dial-up Connections in Windows 2000/ NT). 3 Right-click Local Area Connection and then Properties. 4 Select Internet Protocol (TCP/IP) and then click Properties. 5 Select Use the following IP Address and fill in an IP address (between 192. 168. 1. 12 and 192. 168. 1. 254). 7 6 Type 255. 255. 255. 0 as the Subnet mask. 7 If your Internet Service Provider (ISP) gave you Domain Name System (DNS) settings, enter them in the Use the following DNS server addresses fields. A DNS server translates domain names (e. g. http://www. zyxel. com) into the IP addresses your Internet browser uses to navigate the web (e. g. If you are not sure of your DNS settings, contact your ISP. 8 Click Advanced. 9 Remove any previously installed gateways in the IP Settings tab and click OK to go back to the Internet Protocol TCP/IP Properties screen. 10Click OK to close the Internet Protocol (TCP/IP) Properties window. 11Click Close (OK in Windows 2000/NT) to close the Local Area Connection Properties window. Close the Network Connections window (Network and Dial-up Connections in Windows 2000/NT). 8 Configuration Open your Internet browser and enter the URL of a web site in the address bar. Your G-470 automatically searches for wireless networks. If any other screens appear, follow the directions in the screens. If the web page opens correctly, your G-470 is ready to use. If the web page does not open, you need to set up your Internet connection. [. . . ] · If you still have problems, refer to the User's Guide for information on changing your wireless settings or contact your local vendor. If you cannot access the Web Configurator using Internet Explorer in Windows XP or Windows Server 2003: · Make sure you allow pop-up windows, JavaScripts and Java permissions or set the Internet security level lower than High in Internet Explorer (In Internet Explorer, click Tools > Internet Options > Security > Custom Level. . . ). Important Information Federal Communications Commission (FCC) Interference Statement The 802. 11g Wireless LAN Adapter has been tested to the FCC exposure requirements (Specific Absorption Rate). The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment, under 47 CFR 2. 1093 paragraph (d) (2). [. . . ]