User manual ZYXEL P-630-S3

[. . . ] Double-click ADSLModem 20. 2. 5 P-630-S Series Quick Start Guide 8 Double-click Driver. 9 Double-click Installation of ADSL Modem to install the driver. 10Click Switch Disk to select a destination (this must be on an actual physical hard drive on the Macintosh, not a virtual drive) and click Install. 6 P-630-S Series Quick Start Guide 11Click Restart to reboot your computer and complete the driver installation. Mac OS X Screens for Mac OS 10. 3 are shown in this section. 2 Insert the included CD into the CD-ROM drive. 3 Double-click the Mac X driver folder. 7 P-630-S Series Quick Start Guide 4 Double-click (SMXA. 1. 0. C0)B 1. sit. 5 Select a folder or click New Folder to create a new folder to where you want to extract this . sit file and click Choose. 6 The file ADSLModem. pk g will be created in the folder you selected. Double-click ADSLModem. pk g to install the driver. 8 P-630-S Series Quick Start Guide 7 A welcome screen appears. [. . . ] Type the information from your ISP in the Service Provider, Account Name, Password and PPPoE Service Name fields. Select the Show PPPoE status in menu bar check box. Click Apply Now. 8 Click the PPPoE status menu bar icon at the right corner and select Connect. 2. 2 Setting up Your Computer's IP Address Note: This section shows you how to configure an IP address on your computer. You only need to do this if you were given an IP address by your ISP. 2. 2. 1 Windows Screens for Windows XP are shown in this guide unless otherwise specified. Steps and screen shots may vary depending on the version of Windows. 1 Click Start, Control Panel and Network Connections. 17 P-630-S Series Quick Start Guide 2 Right-click on the icon that corresponds to your new USB connection (not the one that corresponds to your network card) and select Properties. 3 In the Properties screen, make sure the Connect using field displays "LAN/ATM/ADSL miniport". Select Internet Protocol (TCP/IP) and click Properties. 18 P-630-S Series Quick Start Guide 4 Click Use the following IP Address and fill in the IP address, Subnet mask and Default gateway (given by your ISP) fields. Click OK. 2. 2. 2 Mac Mac OS 9 1 Click the Apple icon, Control Panels and TCP/IP. 2 In the TCP/IP screen, select PPP, Routed ADSL Modem or Bridged ADSL Modem in the Connect via field and Manually in the Configure field. Fill in the IP address, Subnet mask and Router address (given by your ISP) fields. Click the close button at the top left corner and click Save. 19 P-630-S Series Quick Start Guide Mac OS X 1 Click the Apple icon, System Preferences and Network to open the Network screen. 2 Select Ethernet Adaptor (en x) that corresponds to your new USB connection in the Show field. Click the TCP/IP tab and select Manually in the Configure IPv4 dropdown list box. Fill in the IP address, Subnet mask and Router (given by your ISP) fields. Click Apply Now. 3 Troubleshooting PROBLEM None of the LEDs turn on. CORRECTIVE ACTION Make sure your computer is turned on. Check the USB cable connections between the Prestige and your computer. Check the USB cable (see if the USB cable works with a different USB device). Carefully follow the instructions to uninstall and reinstall the driver. See your User's Guide on how to uninstall the driver. [. . . ] Follow the on-screen instructions to search for the Prestige and install the driver. In Windows, click Start, Settings, Control Panel, System, Hardware and then click Device Manager. Verify the status of the Prestige under Network Adapters. (Steps may vary depending on the version of Windows). [. . . ]