User manual ZYXEL P-660HWP-DX QUICK GUIDE V3.40

[. . . ] Make sure the power outlet is switched on. This socket will also act as your HomePlug AV connection. 5 Look at the lights on the front panel. · The POWER light (LED) blinks while your P-660HWP-Dx starts up and stays on once it is ready. · The ETHERNET, WLAN, DSL, INTERNET and POWERLINE LEDs turn on if the corresponding connections are properly made. Check your connections if an LED does not turn on. [. . . ] See the Users' Guide for more information on OTIST. 2 Configure your wireless settings in the screen displayed. Click Next. 3 If you select either WEP or WPA-PSK security (recommended), then follow the directions to enter the appropriate key. Click Next to continue and Apply to save your wireless LAN settings. 4 Check your configuration in the screen below and write down your wireless LAN settings for later use. 6 P-660HWP-Dx Quick Start Guide 5 Click Finish to complete and save the wizard setup. Your Internet connection is ready for you to use. Open a browser such as Internet Explorer and navigate to a website. 4 Setting Up a Wireless Network To set up a wireless network you need at least one wireless network card/adapter. · If you have a desktop computer, use either a wireless USB adapter or a wireless PCI adapter. · If you have a laptop, use either a wireless USB adapter or a wireless CardBus card. To add a computer to your network you need to configure your wireless-enabled computer with the same SSID, channel and security settings as the P-660HWP-Dx. Alternatively, use OTIST, ZyXEL's One-Touch Intelligent Security Technology (OTIST) feature. It allows you to automatically configure the SSID and WPA-PSK on all OTISTequipped wireless clients within range of the P-660HWP-Dx. See the Wireless LAN chapter in the Users' Guide for more information on OTIST. 5 HomePlug AV Network Setup Follow these steps to set up your HomePlug AV network on standard electrical wiring with a new password. 1 Plug your P-660HWP-Dx and other HomePlug AV devices into power outlets and turn them on. Your P-660HWP-Dx will try to detect other HomePlug AV devices on the same electrical wiring. 2 Check the POWERLINE ( ) LED for a HomePlug AV connection. · If the LED does not display, your device has a problem detecting another HomePlug AV device. Go to Troubleshooting for more information. · If the LED light is green, the P-660HWP-Dx detects other HomePlug AV devices and you are ready to set up your network. You need to configure the power line settings of the P-660HWP-Dx, as well as the power line settings of the other devices you wish to add to your network. 3 Go to Network > Powerline > Local Setting to configure the P-660HWP-Dx's power line settings. · Select Enable Powerline. 7 P-660HWP-Dx Quick Start Guide · Type the Network Password for your network. This will connect you to other HomePlug AV devices which have the same password and allow you to configure them. [. . . ] 2 If you are using Bridge mode (check Mode in the Network > WAN > Internet Connection screen) click NAT > General and ensure Active Network Address Translation (NAT) is not selected. Click LAN > DHCP Setup and ensure that DHCP is set to None. Your ISP gives your computer an IP address directly. If you want to access the P-660HWP-Dx again, you need to use a static IP address in the same subnet as your P-660HWP-Dx (the P-660HWP-Dx's default IP LAN address is http:// 192. 168. 1. 1). [. . . ]